This is the original type of needle valve that governs the plastic fuel float in your SU carb.

An alternative better upgraded version is available as CA90.

For HIF38 carbs,this is the full rebuild kit with the spindle and throttle disc and bushes--- see CSK94 for service kit

complete overhaul kit for non turbo HIF44 carb includes needle valve and throttle shaft plus spindle--See CSK75 for service kit less spindle and disc

Metal bracket that fits between the manifold and the HIF44 (1.75")carb to hold the cable - the choke cable clip for this bracket is CZK6491. Also for HIF38. For HS4 carb see 12G766 bracket. Original Turbo type [...

jet for HIF38 carb and is 0.090 size--for HIF44 see WZX1453A

This float is ethanol tolerant and will fit all HIF38/44 carbs and the spindle is CUD2082 ..Quantity required-1 set for single carb.

Turbo uses WZX1095 needle valve. An expensive puncture proof stay up float is av...

bearing and needle jet kit(not carb needle) for both HIF38 and HIF44.

.Quantity required for single carb-1 set.

The little spring that sits at the end of a spring loaded carb needle on late HS and all HIF carbs where applicable.

Before the days of Aeroquip, Minis were fitted with braided steel rubber fuel lines. They should be used in place of rubber for all fuel lines in the engine compartment. They come made to length, with rubber end caps. 1/4" bore size.

This is...