SPINDLE KIT HIF44-EARLY METRO
WZX1127

£15.78 exc vat

£18.94 inc vat

In stockIn stock
spindle and fixings only for HIF44, only with one end threaded as opposed to WZX1128 which is threaded both ends-see WZX1183 for disc

£15.78 exc vat

£18.94 inc vat

In stockIn stock

Recommended usage 1 x WZX1127 to fit one mini.
HIF44 Carburettor 44mm 1.75 inch - Qty 1
Carburettor HIF38 and HIF44 - Qty 1

People also bought products

spindle threaded both ends for HIF44 for most late carbs--see WZ1127 for spindle with thread one end only as per early metro cars. Thread size is 1/4 BSF

spindle and fixings only for the HS2 carb-the butterfly for this is WZX1320.

sorry folks but buying both kits you get double the gaskets

jet assembly (0.100") for the HIF44 carb only- see MGM10008 for HIF38(0.090")

This is the original type of needle valve that governs the plastic fuel float in your SU carb.

An alternative better upgraded version is available as CA90.

spindle to hold the float to the float lid on the bottom of HIF carbs only.

the float is WZX1509A and needle valve is WZX1099A except turbo which is WZX1095

Standard spring for all HS2 and HS4 on minis except for the 997/998 Cooper from 1964-9 and H4 special tuning carbs which used AUC4587.

Complete with screw the choke trunnion is used on nearly all SU carb linkages.

See ACC5062 for carb cable link trunnion also.

These screws fit all HS type carb butterflies to hold them on the throttle spindle

Pin to hold the accelerator cable which locates in the carb bracket lever. Supplied as originally fitted with washers, nut and split pin plus a proper machined hole for the cable unlike many others on the market- which come either bare or with wrong ...

Worn throttle spindles cause erratic performance from your carb and sometimes the housing gets worn--These are the bushes to repair worn carbs when replacing spindles for HS4 carbs. As a guideline 0.3125" internal diameter ream body to 9...

Paper gasket for the float bowl of any HS2/HS4/HS6 carbs.

Clip for holding the choke cable on the HS carb abutment bracket 12G766.

The correct one for the origianl HIF44 carbs fitted to 1990-92 1275cc Coopers

float lid screw for all HIF type SU carbs

This is the original type of needle valve that governs the plastic fuel float in your SU carb.

An alternative better upgraded version is available as CA90.

Throttle disc only for HIF44-non turbo and if replacing the spindle there are 2 type, threaded one end only use WZX1127 for very early carbs 1980-81 only, but all later cars were threaded both ends use WZX1128

plain butterfly with small hole at bottom for HS4 waxstat jet type carb and uses WZX177 spindle-or see kit full rebuild kit CRK121. This is usually fitted to FZX3013 replacement carb --same size butterfly on all...

this is the plain butterfly disc for the HS4 1.5" carb and if you have the air valve type butterfly disc see WZX1325

bearing and needle jet kit(not carb needle) for both HIF38 and HIF44.

.Quantity required for single carb-1 set.