For vans and pickups this had later type hinge positions 1.25" from the edge as per the saloon but did not have the extra lip for the bonnet upper grille moulding which was never fitted as standard---Mk1/2 variants had the hinges in a different posit...
Japan spec only, From 1996 Japan cars were still single point injection and although using a MPI type bonnet the safety catch was retained on the righ hand.
The UK cars had the bonnet safety catch in the middle whereas the Japanese spec lef...
Non genuine part.
This bonnet will fit Mk3,even 1970 models as it has dual hinge positions.
Early cars had a gap of 23" between hinges and later had 34" gap.
The NEW MKI bonnets from Original tooling are now available They are being made from the original tooling and absolutely correct. The exact contours, hinge location, etc. etc. fits all '59 thru '67 models of the Mini.
The front hood or bon...
High tensile long cylinder head stud, 4 required per head, sold individually. Torque to 42lb/ft. See also the complete kit which includes these top grade studs C-AHT279.
This is the Mk2 bonnet which is the same as MK1 except it has a lip attached to mount the grille moulding. The hinges are mounted 6" in from the edge on this bonnet and the later MK3 they are moved out to 1.25" from the bonnet edge.
Please c...
Genuine bonnet lander panel for the Clubmman. See MS149 which is the non genuine alternative.
British Heritage produced as original equipment, this Bonnet will fit all models beginning with the MK3. It is distinguished from the early models by the hinge location 1.25" from the edge and the lip for mounting of the upper grille moulding.See [l...
Outer skin only without any fitting facility used mainly by motorsport competitors or for specials where the method of fiting and retaining the bonnet by pins or straps is upto the individual. This has the bonnet moulding lip so the grille upper surr...
Outer skin only without any fitting facility, used mainly by motorsport competitors or for specials where the method of fiting and retaining the bonnet by pins or straps is upto the individual.
non genuine small lip om front of Mk2/3 bonnet
this lip holds the upper grille moulding on Mk2 saloons right up to the last cars. Fitted to all our bonnets except van types and MK1 saloons it is usually found on any new bonnet and is tacked/...
the vertical panel that sits between the bonnet slam panel (MS149) and the front panel on clubmans only
Available again from genuine tooling
Fits all mini clubmans only. There is no aftermarket version available of this bonnet anymore.
this bonnet MUST use the later 1981 onwards BMP348 / BMP349 hinges
Outer skin only without any fitting facility used mainly by motorsport competitors or for specials where the method of fiting and retaining the bonnet by pins or straps is upto the individual. This has the bonnet moulding lip so the grille upper surr...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.