genuine panel that holds the headlamp assembly on the mini clubman versions.
this is the left hand side
For Minis with sliding windows and external door hinges These genuine L/H outer A panels fit over the extra inner panel which have brackets on to reinforce the exterior hinges. If the outside one is rotten you can guarantee the i...
For the twin point only as it changed shape to accommodate the front mounted radiator and different bonnet opening location fittings. Also has holes for 4 extra lamps fitted as standard
Genuine door hinge panel R/H for all Minis with internal hinges and doors that have wind up windows. Although it is a single wall panel it still has a tendency to develop rust spots but a slightly thicker upgraded panel the local bodyshops love is [l...
The left side inner fender of the MKI/2/3 pre 1975 Mini should have a metal cowling to focus the air from the radiator to the wheel well. The almost square cowling is spot welded to the inner fender and has the tabs on it that in turn hold the rubbe...
This is the engine stabiliser bar original lower bracket that is welded on the
engine bay bulkhead. This part often breaks away when the engine has been rocking around through poor maintenance of engine mounts and bushes.
The upper...
the complete windscreen surround panel up to the roof but see HMP441001 for the part that rusts
This front to rear rod change floor pan is based on the last type of floor pan used where a large stiffener gusset went down the length of this panel to house the extra injection fuel lines which disected the front footwell tray making it very strong...
This front to rear rod change floor pan is based on the 1991on floor pan shape which had a smaller footwell tray in the front making it stronger and less liable to vibrate. Rover undertook a lot of effort modifying the panelwork to get noise levels d...
Genuine door hinge panel L/H for all MK3 Minis with internal hinges and doors that have wind up windows. Although it is a single wall panel it still has a tendency to develop rust spots so the trade prefer the best fitting thicker upgraded [link]ALA5...
N/S/F wing without ariel hole which was standard fiment for 1996 on cars which had a factory fitted roof ariel. THIS WING STILL NEEDS MODIFYING to allow for fitting of Sportspac arches and 13" wheels. After trimming/cutting to size remember to replac...
For Minis with sliding windows and external door hinges These genuine R/H outer A panels fit over the extra inner panel which have brackets on to reinforce the exterior hinges. If the outside one is rotten you can guarantee the i...
Minis most used rubber plug 1.25" wide for holes approximately 7/8".
Fits floor, aerial hole and steering column extra hole and radius arm shroud on MK1/2 minis.These floor plugs vary in number from 11 in a Elf/Hornet,Mk1 and 1994 on cars do...
genuine panel that holds the headlamp assembly on the mini clubman versions.
this is the right hand side
This panel is for wind up window type doors that have internal hinges and this contains the part of the front A post where the hinge and door stay holes are down to and including the door step and along and up the B post a few inches covering the mai...
For Minis with sliding windows and external door hinges These NON genuine L/H outer A panels fit over the extra inner panel which have brackets on to reinforce the exterior hinges. If the outside one is rotten you can guarantee t...
For Minis with sliding windows and external door hinges. These NON genuine R/H outer A panels fit over the extra inner panel which have brackets on to reinforce the exterior hinges. If the outside one is rotten you can guarantee ...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.