($251.76) £251.76 exc vat
($302.11) £302.11 inc vat
Special order
($251.76) £251.76 exc vat
($302.11) £302.11 inc vat
Special orderRecommended usage 1 x YMC11858 to fit one mini.
Rear wiring loom for SPI cars. These have bullet connectors to join the front loom, later cars had a multiplug which use YMD10717.
SPI with dim dip-fuel injection cars. Just the main loom only, does not include the engine harness or rear loom. With factory alarm.
Harness to ECU for SPI manual models to chassis number BD 059821 has 2 plugs that connect to the ecu.
Rear body harness with speaker wires, known as thick wall type which was replaced by thin wall PVC covered wire type in 1989. AN169 is the thin wall equivalent and occassionly fitted or found on early cars wothout any problems.
...
All Minis require an earth strap from the engine to the body and from 1959-1996
they fitted from the gearbox to the subframe. When they introduced the twin point in 1996 it was moved to the upper engine stabiliser arm. About 13"LONG.
This is the wiring short conversion loom that fits to the old central speedo and is used by people modifying from 2 or 3 clock dashes to single clock or just repairing damaged looms. With the correct bulb holders and spade fittings. Now uses 5x [link...
Large grommet to fit 1"approx holes in bulkhead for items that need to be able to flex and move such as capillary tubes and oil pipes. 7/32" hole size.
The small hole will expand and is also used as wiring loom through bulkhead and battery c...
This plug fits the hole in the inner wing where the wiring for the wing side repeater lamp goes through the body on cars after 1986.
Rocker switch for all models with front fog lights fitted as standard. Please note the lens colour is now green. 6 pins on the back for plastic loom connector.
Rear fog lamp switch with the orange illumination segment for all vehicles fitted with production fog lamps as standard. 3.1cm tall from 1976 on.
This later type oblong fuse box cover was fitted to the box that held 4 fuses as opposed to two and was fitted from 1976-1996.
Complete fuse box less fuses is RTC440A.
MK1/2/EARLY MK3. 3 position spring loaded type. Comes with barrel.
For barrel only use part number 24G1345.
2.2 WATTS and fits back of gauges in cars with 3 extra 52mm round clocks.
Minis always looked better and safer from vandalism with a roof ariel.
High output, uprated to 70amp (from 45 and 55amp) alternator as used on 89 on model Minis.
Will fit most Minis from 1980 until 1996, except some aircon models (requires transfering the old twin belt pulley to new alternator - see ...
Thermal transmitter fitted in the cylinder head from 1970 on until its demise on the 1990 Coopers this part was the same as GTR143. One number was original fitment and the other supplied as the spare part by Unipart.
Fits 998 1275 and cooper...
This sleeve fits most Lucas and Unipart coils to give the impression thay are stainless steel. Comes with a s/steel bracket. Covers just over 4.25"(11cm)long
This switch fits under the brake pedal on the floor. See also BMK1903A locknut for this item.
Fitted under dash rail in cabin
cover for this part is YQH100720PMA
This battery lead front to rear is 127" long. Cars from 1985-1990 had a 134" lead and is AAU1089. Automatics had 131"long cable.
Measure your old cable to see if this will fit because the later cars had it routed different alon...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.