£52.50 exc vat
£63.00 inc vat
In stock
Will fit most Minis from 1980 until 1996, except some aircon models (requires transfering the old twin belt pulley to new alternator - see ...
£52.50 exc vat
£63.00 inc vat
In stockRecommended usage 1 x GXE2297 to fit one mini.
This lightweight alternator is favoured by competition users, new design for 2014 these are now a direct replacement for the original alternator so no additional brackets are required. A small amount of wiring required to fit the Mini wiring loom.
Lightweight competition alternator for all pre 1997 mini's. This unit weighs 3.2kgs and outputs 55 amps. Designed as a direct bolt on replacement but features a multi position mounting bracket so ideal for race cars/custom applications also. Does not...
This lightweight alternator is favoured by competition users, new design for 2014 these are now a direct replacement for the original alternator so no additional brackets are required. A small amount of wiring required to fit the Mini wiring loom.
Most MGBs are wired for five-terminal alternators. As the five-terminal alternator is N.L.A., the current three-terminal alternator must be substituted. These wiring instructions supplied by Lucas outline the conversion procedure. To wire a three-...
This very trick pulley is machined from billet aluminum & black anodized. It is oversized (5") to reduce the speed of the generator or alternator on high rpm engines preventing over charging the system.
When using this pulley with the origi...
Special bolt that fits the engine front plate to support the adjusting link for alternators/dynamo
Alternator bracket fitted on the block of earlier Pre A series engine blocks.
For later A plus blocks see CAM4853
Alternator bracket for A Plus engines and Pre A+ engines with dynamo fitted. See 12G1053 for earlier Pre A plus alternator bracket.
Fitted from 1996 only this alternator sits higher than originally, with new brackets that will only fit the twin point injection cyl head. A1151-65 type producing 65amps (Was GXE2862 from Unipart). If your battery seems to be always running low it mi...
Brand new 45 amp uprated alternator without any surcharges comes with the pulleys fittted which are worth over ten pounds retail. This will cope with all those extras you might have bolted on such as spots and music systems.
Replaces the ori...
LARGE ALLOY HEAVY DUTY ALTERNATOR BRACKET FOR ALL PRE A PLUS ENGINES(PRE 1980) AS USED ON ABINGDON ST WORKS CARS
The adjusting link bracket for dynamo and alternator that fits on the 12G289 pillar.
Wiper motor fitting kit to fit all mk2 onwards wiper motors to the bulkhead.
Wiper motor kit for all mk2 onwards cars, includes wiper motor, motor gear, wheel boxes, outer tube kit, wiper rack and wiper motor ferrule.
Main wiring grommet that fits in the front parcel shelf. ID 12.5mm fits 35mm hole.
Interior lamp with a black on/off switch and pointed torpedo ends.
Also fitted many of the 1959on range of Austin A55/60 Cambridge, MG Magnette etc.
Also there was an alternative lamp with black switch and square ends 13H192 which w...
Lightweight billet aluminium distributor hole blanking plug for A+ engines.
Battery bar and fitting kit for all pre 1990 cars whcih had the shorter battery bolts.
Mini Mk 4 998 oval centre dash,twin column stalks,rocker switches including rear fog and heated rear window,reverse lights and rear fog lamp is on headlamp circuit. Intertia starter. To go with AN145 rear loom.
mainly for 1980-1...
Stainless steel small battery cable retaining bracket bolted at the front of the engine for pre engaged manual cars approx 1985 onwards.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.