£5.78 exc vat
£6.94 inc vat
In stock
£5.78 exc vat
£6.94 inc vat
In stockRecommended usage 1 x TAM1918SS to fit one mini.
Battery bar and fitting kit for all post 1990 cars whcih had the longer battery bolts.
Cable for solenoid to inertia starter on Pre-1985 minis or can be used as a long earth cable.
Your battery box 5L877 should be held in place by this rubber strap.
Best quality available-there are so many unreliable imports we have gone to Intermotor one of the original suppliers since the demise of original Lucas.
The activation of the starter motor starts with the key (or push button in the early car...
Universal battery clamp replacement with securing bolts and marked P.
The only battery cable to run the full length of the Mini, this has a positive type terminal that clamps arond the post rather than the helmet or cap type on much earlier cars. Some cars had slightly shorter cables than this but measure your old cabl...
This new modern high-torque pre-engaged starter is used on all Minis 1985-on.
Should only be used with the correct corresponding ring gear PSF10003 which has 129 square section teeth. These units are now sourced brand new, no o...
Main wiring grommet that fits in the front parcel shelf. ID 12.5mm fits 35mm hole.
This is the hazard switch repair plug for post 1976 rocker switches, pins supplied so you can wire accordingly.
Lots of things have been written about performance plug ignition wires but regardless of what you believe we all know that good wires are a must. This special competiton wires set from the Lucas factory has 8mm wire and the highest performance, no br...
A Plus Electronic Ignition distributor with vac unit, modified to our spec in UK to give best performance on any minis with std to 276 camshaft profile.
Ideal for our EVOLUTION001 camshaft
Brand New distributor complet...
Rear body harness with speaker wires, known as thick wall type which was replaced by thin wall PVC covered wire type in 1989. AN169 is the thin wall equivalent and occassionly fitted or found on early cars wothout any problems.
...
Plastic body sensor for the camshaft timing on twin point cars only. Fits in the hole originally used for the mechanical fuel pump.
This is the latest model fuse box as used on all Minis after 1976 and all MG Midget/Sprites with 1275cc. Simple and easy to replace or upgrade from the earlier version. This box has the added advantage of having 4 fuses in place of the earlier vers...
Minispares design heavy duty STAINLESS STEEL spotlight bracket, for fitting to cars where it mounts on the front panel valance and grille support panel, giving it perfect rigidity so that the power of the lamp was not impaired. Many cheap aftermarket...
All Minis require an earth strap from the engine to the body and from 1959-1996
they fitted from the gearbox to the subframe. When they introduced the twin point in 1996 it was moved to the upper engine stabiliser arm. About 13"LONG.
This later type oblong fuse box cover was fitted to the box that held 4 fuses as opposed to two and was fitted from 1976-1996.
Complete fuse box less fuses is RTC440A.
The O ring that actually sits on the distributor drive spindle shaft in the recess provided.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.