3RD GEAR A TYPE
22A583

(26,00 €) £26.00 exc vat

(31,20 €) £31.20 inc vat

Out of stockOut of stock
3rd gear for early mini A type 850 gearbox--has 23 teeth

(26,00 €) £26.00 exc vat

(31,20 €) £31.20 inc vat

Out of stockOut of stock

A Type Gears - Qty 1

People also bought products
INPUT / BROACH GEAR PRE A PLUS 24 teeth
22G849

Input Gear 4-synchro gear.24 teeth

can be used on 3 synchro but the stem part is shorter so you will need to use a spacer by cutting up your old 3 synchro input gear to act as a spacer.

(39,00 €) £39.00 exc vat

(46,80 €) £46.80 inc vat
GEARBOX 4 SYNC REBUILD KIT LESS DIFF PRE A PLUS ST...
MSG16

Full rebuild kit less differential parts, supplied with standard layshaft

Using only the original manufacturers of the bearings such as RHP because all the budget bearings are not good enough for longevity or performance use.

This...

(227,82 €) £227.82 exc vat

(273,38 €) £273.38 inc vat
BALL BEARING FOR SYNCHRO HUB 3&4 SYNCHRO
BLS107

Inside your gearbox synchro hubs are 3 springs and these ball bearings to lock it in and out of gear. Often pop out and get lost when splitting the inner and outer hub.

(0,45 €) £0.45 exc vat

(0,54 €) £0.54 inc vat
GEARBOX GASKET SET(GUG708010TS)
AJM804B

Mini Spares own Gearbox gasket set for all manual Mini transmissions. It does not include the clutch oil seal 13H2934 or output shaft seals ADU5738 or 13H577 selector shaft seal for pre rod change gearbox becaus...

(8,88 €) £8.88 exc vat

(10,66 €) £10.66 inc vat
DIFF OUTPUT SHAFT OIL SEAL
ADU5738

Drive shaft oil seal or diff output shaft oil seal for all Mini's except Cooper S and early Automatics. 2 required per gearbox.

Upgraded version in Viton available us ADU5738VITON

(0,91 €) £0.91 exc vat

(1,09 €) £1.09 inc vat
GEARBOX EXTENSION REAR MOUNT (REMOTE)
21A956

This mounting fits on the end of the remote control housing of pre rod change cars. The metal bracket that it secures to is 21A745.

(3,02 €) £3.02 exc vat

(3,62 €) £3.62 inc vat
SYNCHRO HUB SPRING. 4 SYNCHRO ONLY
22G2262

Only for the 4 synchromesh gearbox synchroniser gear hub. There are 3 of these per hub with BLS107 ball bearing.

(1,05 €) £1.05 exc vat

(1,26 €) £1.26 inc vat
NUT 1ST MOTION SHAFT
2A3548

Nut to hold the broach (input) drop gear on the 1st motion shaft and don't forget the DAM4000 locktab. Tiny cut-outs / chamfers go towards the gear as not to dig into the lockwasher as the nut is done up.

(4,50 €) £4.50 exc vat

(5,40 €) £5.40 inc vat