(36,00 €) £36.00 exc vat
(43,20 €) £43.20 inc vat
In stock
(36,00 €) £36.00 exc vat
(43,20 €) £43.20 inc vat
In stockRecommended usage 1 x C1503 to fit one mini.
5/16"unc cap head bolts 7/8"long for attaching the air cleaner alloy elbow to the carb on all HS2/4 and HIF.
special offset cone type filter for HS6 carbs only -about 2.5" deep
Minispares original filter fits all single and twin point injection models
sold at nearly half the retail price.
Minispares branded filter from the original and approved Rover/Unipart supplier until 2014
Large air filter element for Mini with HS4 carb which is visible through the center of plastic filter case,also Austin America, MKIII Canadian
For the equivalent K&N cleanable element see E-2601.
Minispares product fro...
Pipercross KK150 chrome top, low-conical, foam air filter for 1.5" SU carb.
Full flow, high capacity competition foam air filters; the KK range of Pipercross high performance air filters offer the ultimate in engine filtration, and are ...
Minispares spin on oil filter from the original suppliers as designated and approved by Rover/Unipart until 2014. Original filter for twin point injection cars where it screws directly into the block.
See GFE210 for shorter fil...
Genuine Minispares spin on oil filter from the original suppliers as designated and approved by Rover/Unipart until 2014 when parts quality selection changed.
Same manufacturer and item as GFE443 but with our livery on so you know you are g...
Return spring kit for HS4 carburettor spindle.
Mini Spares Non Genuine version mechanical fuel pump. Brilliant aftermarket alternative for cars pre 1990.
Drives off the camshaft at the rear of the motor. These pumps are generally reliable but when a diaphragm goes bad it can be very bad ...
For HIF38 carbs,this is the full rebuild kit with the spindle and throttle disc and bushes--- see CSK94 for service kit
Not fitted as standard to the A seriers it found its way on engines as a great tuning aid on tuned engines. this is the spindle only and the disc is WZX1321.We suggest you use a complete rebuild kit if this area has worn-CRK223 which will have to be ...
Spanner for adjusting the jet on silver coloured original jets on HS type carbs
short handle to enable use in tight places such as a mini engine bay.
WILL NOT FIT LATEST BRASS TYPE ADJUSTER NUTS AS FITTED TO REPLACEMENT CARBS SINCE ...
The little spring that sits at the end of a spring loaded carb needle on late HS and all HIF carbs where applicable.
Saloon petrol tank retainer clip for the rubber seal on the sender unit which is ARA1502 .Early tanks had 6 screws holding the sender unit in place and used gasket GUG705711GM
Worthwhile fitment on any car and a must for performance engines. This filter has 1/4" ends for standard use, for 5/16" larger bore see PRO805. Supplied as per picture.
Silver top standard 4.0 to 4.5psi, 18 gallons per hour ideal for high output engines using a twin choke carburettor such as Weber and Dellorto with chokes upto 45mm, plus all single SU carbs, plus most twin SU set ups. 1/8" nptf threads and uses 1/4"...
Carb repair kit less spindle and butterfly for twin HS6 carbs-includes float needle valve and jet.
This is the original type of needle valve that governs the plastic fuel float in your SU carb.
An alternative better upgraded version is available as CA90.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.