With this large diameter line to the oil pressure guage you can actually see minor fluctuations in the pressure at idle or when the relief valve bounces open and closed. Because the braided steel line is one piece from the block to the gauge there is...

Oil pipe in plastic 5 feet long, if fitting to a Tim gauge you will require LMA017 adaptor for the gauge.

Not comppatable with the CAM6431 standard oli pressure block union, and OA shoudl be purchased to fit.

29" long for L/H/D cars from about 1988 on when Seiko nippon speedo gauges are fitted. earlier cars used a 33" cable GSD102 which had the grey end but are interchangable and cheaper.

Male to female brass spacer/adapter for mechanical water temp guage screws into head & accepts capillary tube. Required for SIB422 and SIB422MG. Also fits in MOCOT1

If you have an early Mini saloon or Estate/Van or Pickup with the fuel tank sending unit held in by screws, this is the correct screw for you.

Do not forget the special copper washers also 2A2088 and the cork gasket [link]2H10...

Longest cable we keep for fitting a Smiths central type speedo when engine in rear of kit car. This is the correct cable for a Sprite or Midget, not a universal cable. Includes inner cable and outer sheath.

48" extra long speedo cable for special fitmentswhen using original type Smiths central mounted speedo.

Speedo cable for most Innocenti made minis which had Veglia speedo clocks.

26"

This is the original type of metal pipe that fitted from the engine to the

hose on cars with central speedo and gauges. The pipe that went from the rubber hose to the gauge was 21A804. The hose is FAM2807.

...

Standard replacement cable for central located Smiths Mini speedometer.