£60.59 exc vat
£72.71 inc vat
In stock
Can be fitted to MK3 front loom ( HAM2174 ).
£60.59 exc vat
£72.71 inc vat
In stockRecommended usage 1 x 5L875 to fit one mini.
Main wiring grommet that fits in the front parcel shelf. ID 12.5mm fits 35mm hole.
Front loom only. MK4. Center speedo,inertia starter,rear fog switch.
non ballast coil,last with centre clock
Rear body harness with speaker wires, known as thick wall type which was replaced by thin wall PVC covered wire type in 1989. AN169 is the thin wall equivalent and occassionly fitted or found on early cars wothout any problems.
...
We sell about 20 of these per year and many are used on similar models to those indicated-Main and dash loom only--No side wing indicators-indicator stalk on right-alternator-rear lamps with reverse lights-steering lock-inertia starter-centre speedo ...
All Minis require an earth strap from the engine to the body and from 1959-1996
they fitted from the gearbox to the subframe. When they introduced the twin point in 1996 it was moved to the upper engine stabiliser arm. About 13"LONG.
Universal post type battery earth strap with clamp type fitting and correct length for most alternatives of batteries fitted.
The battery cover made of a special cardboard as fitted to all minis to protect
the battery terminals from metal objects. See also the 14A7666 retaining strap.
This is the wiring short conversion loom that fits to the old central speedo and is used by people modifying from 2 or 3 clock dashes to single clock or just repairing damaged looms. With the correct bulb holders and spade fittings. Now uses 5x [link...
1976 facelift type on in PVC for 1275GT only
Instrument pack wires require use of your old wiring block.
A plastic lamp spade connection with sidelight bulb aperture for use on sealed beam units only. Uses a GLB501 capless bulb. The mini clubman used sealed beams but had independant side lamps and therefore had an equivalent unit less the s...
998cc minis with central speedo and alternator from 1972-75. This is a front loom only.
The only battery cable to run the full length of the Mini, this has a positive type terminal that clamps arond the post rather than the helmet or cap type on much earlier cars. Some cars had slightly shorter cables than this but measure your old cabl...
First of the thin wall looms, fits 998 cars October 1988> from chassis number 396449 on with a brake servo fitted and dim/dip relay on the headlamp flashers. All cars with side repeaters on the wings, 3 clock cluster, pre engaged starter. L/H/D cars ...
Basically just the rear lamps and number plate lamp wiring loom for mini van.
In pvc tape covering as original for dynamo type Cooper S MK2 cars, 3 wires to wiper motor. Complete with rear loom.
Braided BLACK cotton covering with yellow flashes,this complete loom fits MK2 Cooper S with alternator and 3 wires to wiper - pre wiper plug type.
Complete with rear loom.
Braided rear part loom ONLY for MK1 Minis without a rear heated screen.
Large grommet to fit 1"approx holes in bulkhead for items that need to be able to flex and move such as capillary tubes and oil pipes. 7/32" hole size.
The small hole will expand and is also used as wiring loom through bulkhead and battery c...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.