BOLT M8X120MM
FB108241

£1.18 exc vat

£1.42 inc vat

In stockIn stock
Bolt for the top alternator bracket on mpi cars.

£1.18 exc vat

£1.42 inc vat

In stockIn stock

Recommended usage 1 x FB108241 to fit one mini.
Alternators and Starter - Qty 1

People also bought products

5/16" UNF THREAD 2 1/2" LONG bolt commonly used for 21A2838 petrol tank strap

FIA spec anchor plate for eye bolts, used when fitting harnesses. Sold individually, 7/16 UNF 65x65x3mm.

Screw for chrome metal number plate lamp on mk3 19790 on - You will have to drill the lens out to take M4 screw.

Special thread cutting screw 1/4 UNF 1.25" (31mm) long.

Screw to hold the lock assembly on the door of MK3 cars with internal hinges and wind up windows. On new doors or for easy fitment use these special screws with cutting thread (3 sided ...

Clutch housing bolt to engine long 5/16" UNF 1.75" long with tuflock patch to secure. Earlier bolts less tuflock are {link]BH605141{/link}

Self tap screw No10 for holding wiper motor strap to body and any other use.

M10 metric flanged bolt 35mm long for catalytic converter. (4 required per unit)

Remote type gearboxes had four UNC bolts holding the long alloy housing to the differential case. These are the shorter two, 3/8"unc 1"long. The longer two are ZCS628.

Also the bolt to hold the starter motor.

Also the bolt for the [...

There are 3 of these bolts fitted -1.75"long 5/16"UNF bolt ALTERNATIVE DAM7758.

Also used as longer bolt for water pump.

Also for the 21A1091 heavy duty tie rods on front suspension.

Bolt for CHM85 differential side cover. 1" long UNC useful for pre verto slave cylinder and starter bolt. Also 12A361 engine mounting bracket to alloy case.

Front subframe to front teardrop mounting, clutch case to block.

Engine mounting to subframe - easier to use than the GFK5184 - 3/4" long

Bolt used in our anti roll bar kit and for holding plate on speedo drive housing on gearbox

This 5/8unf steel hexagonal head blanking plug was made for the inlet manifolds where the servo union can be fitted, plus blanking off the thermal transmitter hole under the thermostat. Uses 1B3664 washer ----------please note this will ...

Bolt for the overider to lock plate at the back of the overider to secure it against the bumper.

Also has been used for the rear subframe trunnion 2A5819/21A2558.

Also used for the short water pump bolt.

Longer main bolt stud.

As supplied with our main strap kit.

Replacement screw for the clubman indicator/side lamp lens. 28mm long. Plus fog lamp lens. New stock is threaded along the whole length and made from stainless steel.