HORN BRACKET STAINLESS STEEL
GGE124

£7.88 exc vat

£9.46 inc vat

In stockIn stock
All the horns we sell have a bracket on them but this is the original type from Rover.

£7.88 exc vat

£9.46 inc vat

In stockIn stock

Recommended usage 1 x GGE124 to fit one mini.
Horn & Windscreen Wiper - Qty 1
Horn and Alarm - Qty 1

People also bought products

twin terminal horn with low tone and open trumpet design-often fitted with the hi tone version GGE164 to let people know you really are there.

A working car horn is not only a necessity it is also a legal requirement in England and most other countries.This the single spade terminal with an open trumpet

Horn push assembly for the Mk1 Austin Mini, Mk1 Austin Mini Cooper and Mk1 Austin Mini Cooper S.

For Morris cars, see 27H6944. This horn push assembly can also be supplied without a centre emblem, see 27H6945

A working car horn is not only a necessity it is also a legal requirement in England and most other countries.This twin upgrade open trumpets is just the set you need to be heard.

A working car horn is not only a necessity it is also a legal requirement in England and most other countries.This the single spade terminal with an open trumpet

twin terminal horn with high tone and open trumpet design-often fitted with the low tone version GGE165 to let people know you really are there.

Starter solenoid bracket that bolts to the flywheel housing on MK1/2 cars. For Cooper S see 12A326.

Battery bar and fitting kit for all pre 1990 cars whcih had the shorter battery bolts.

Stainless steel small battery cable retaining bracket bolted at the front of the engine for pre engaged manual cars approx 1985 onwards.

Genuine Bosch lambda sensor, fitted to both the twin and single point injection cars and fitted in the same exhaust manifold shared by both cars. Be warned the cheaper non branded sensors cause lots of issues hence we only sell the Bosch version.

Identical to the GXE1002 competition alternator but with a larger pulley designed to stop over charging the alternator on race cars which spend the majority of time at high rpm. Weight 3.277 kg.

Sports coil for ballast resistor type ignition.

Best internal parts tested and another intermotor top product.

Its not the name on the outside but whats on the inside which matters.

Original type coil bracket 12G29...

Pop rivet for fixing the headlamp bowl to the wing. Great for MS14 metal bowl but be careful if using on plastic bowls

Pre A Plus Electronic Ignition distributor with vac unit, modified to our specification in the UK to give best performance on any minis with std to 276 camshaft profile.

Brand New distributor complete with electronic conversion already fitt...

Lots of things have been written about performance plug ignition wires but regardless of what you believe we all know that good wires are a must. This special competiton wires set from the Lucas factory has 8mm wire and the highest performance, no br...

Small battery cable retaining bracket bolted at the front of the engine for pre engaged manual cars approx 1985 onwards.

Wiper Swithch MK1/2/EARLY MK3 blade type switch for using to convert to 2 speed wipers when current 2 speed wiper motor is used.

Fits our 45/59d distributors, 1275cc as fitted to 12G4180 and ADU3825

Along with our distributor manufacturer we have found this to be the best for modern day fuels for all 45 or 59d distributor for 1275cc uses as...

Rear wiring loom for SPI cars. These have bullet connectors to join the front loom, later cars had a multiplug which use YMD10717.

Gasket/seal for all 1997 on mpi headlamp bowls (self levelling type).