JET ASSY HIF38 CARB MINI
MGM10008

£14.40 exc vat

£17.28 inc vat

Out of stockOut of stock
USE WZX1455A

£14.40 exc vat

£17.28 inc vat

Out of stockOut of stock

People also bought products
CARB NEEDLE SPRING HIF and HS4
AUD3306

The little spring that sits at the end of a spring loaded carb needle on late HS and all HIF carbs where applicable.

£0.78 exc vat

£0.94 inc vat
ACCELERATOR CABLE NYLON SLEEVED EXTRA LONG
C-AHT85

Our heavy duty throttle cable is superior in many ways.

A nylon interior ensures smooth operation. The outer cable is 32mm longer and inner is 95mm longer than the standard one.

Cable to carb bolt is ACC5062.

£6.10 exc vat

£7.32 inc vat
1.5" CARB ELBOW GASKET
GUG705559GM

The paper gasket that goes between the carb and the cleaner elbow or pancake filter on HS4 and HIF38 carbs. For HS2 see 12H862B.

£0.23 exc vat

£0.28 inc vat
HIF44 CARB GASKET 1.75" EQUIV TO 88G429B
GUG705561GM

High quality klinger gasket that sits either side of the carb to manifold spacer on HIF44 type 1.75" carbs or HIF38. Now also sold as PKX100020EVA by Xpart

For a cheaper alternative see 88G429B sold singly.

£1.33 exc vat

£1.60 inc vat
CARB SPRING RED 4.5oz HIF CARBS ONLY
AUD4355

Standard weight 4.5 ounce spring colour coded red for HIF type carbs only.

There is an optional heavier spring coloured yelow at 8oz.

£7.59 exc vat

£9.11 inc vat
MANIFOLD STUD. SUITABLE FOR ALL NON INJECTION MINI...
53K487

Manifold stud 39mm long for all A series engines up to injection which use LYR10028 which is 6mm longer at 45mm.

£0.61 exc vat

£0.73 inc vat
LONG BRASS MANIFOLD NUT
51K1177

Special extra long nuts were used on some manifolds. These nuts are about an inch long for easy reach and made of brass so they'll never corrode. Especially handy on the inner two studs on dual carb set-ups.

Sold singly and usually 2 used f...

£1.10 exc vat

£1.32 inc vat
FUEL FILTER 5/16"
PRO805

A "must" on any performance engine this has 5/16" ends for competition engines where fuel lines have been increased in size. for standard 1/4" See PRO804 Supplied as per picture.

£12.50 exc vat

£15.00 inc vat
VALVE STEM TOP HAT SEAL A PLUS (Single)
ADU4905

As an engine wears, the clearance between the valve stem and guide increases; as this gets beyond tolerances the car will tend to smoke under deceleration (when you take your foot off the throttle). Good valve stem seals will allow for greater wear b...

£0.54 exc vat

£0.65 inc vat