This kit includes all the parts to fit the 13H7939 (SEN43) Mk3 Mini servo. It includes all the parts supplied in the SEN43 servo kit (except the servo) but with the original type brackets rather than universal ones.

The Maniflow steel intake manifold has established the standard by which all others measure themselves. This manifold is specially designed to maximize air flow within the space requirements of a Mini. It accepts either twin 1 1/2" or twin 1 3/4" ...

Special reinforced gasket for injection cars has metal inserts on exhaust ports plus a metal back on the manifold side which makes surface easier to clean when replacing. Often used on Turbo cars when correct gasket is in short supply.


...

Smarten up your engine bay with these stainless steel nuts which are not only stronger and resistant to rust but the multi point nut heads are easier for access. See also kit C-STR287.

Locating rings originally made for 12G295 heads with twin carbs to line up the inlet manifold to the inlet ports on the cylinder head it found its way on most twin carb factory produced cars. There is a recess in the inlet port on the he...

Genuine mini Spares inlet manifold dyno tested and designed for our Stage one kit C-STN17. The single SU manifolds is developed to give maximum airflow and gas speed, yet fit all engines even if the standard air cleaner set-up is used. I...

The newest development in the A-series engine is the use of these nuts with swedged-on washers. The washer will not separate from the nut, so you won't lose it. Yet the nut rotates independently while you tighten it. What a great idea.

Manifold stud for all A series injection engines and some late carburettor cars which is 45mm long-6mm longer than 53K487.carburettor engines usually retained the 53K487 shorter screw for the outside 2 holes.

Sold singly,6 per c...

Cast alloy type,this intake manifold for twin 1.25"SUs (H2 or H4 -- NOT HS4)

It has been carefully produced to minimize cross-port-flow interference caused by the balance tube and has generous radii in all the right places. Further blending ...

This is the clamp on the cooper freeflow manifold to clamp it to the engine for extra support, supplied with tag.

The famous RC40 mild steel exhaust and downpipe with a maniflow LCB plus the fitting kit for the exhaust system. There is NOT enough clearance room when fitting to old cars with rubber couplings which foul. Using QL5000 type...