BUFFER FOR FLITCH/INNER WING GROMMET 8mm
2H7274

(¥1) £0.72 exc vat

(¥1) £0.86 inc vat

In stockIn stock
Buffer in flitch plate and end of MK1/2 door pockets

(¥1) £0.72 exc vat

(¥1) £0.86 inc vat

In stockIn stock

Recommended usage 4 x 2H7274 to fit one mini.

People also bought products

Boot hinge gaskets and fittings for original type hinges

Complete car set of stainless steel screws for the piano hinge type opening rear quarter light windows.

Upper door moulding rivet for Cooper S door trim. For Mk1 usually 1 at front and 3 at back making 4 per side and on Mk2 there were 2 per end at bottom making 4 per side. This is the 10mm head rivet and not required on our own 14A9773/9774 trims that ...

High quality non genuine door check strap for MK3 cars with wind up window doors (use with retaining pin CLZ412). Beware there are cheap copies on the market that are poor quality and when fitted to our cars did not function correctly!

Re-manufactured obsolete part now available to purchase. This is an item that often gets overlooked when rebuilding the doors. It accepts the screws that retain the nylon door guide dovetail. The drain tube also passes through it. Made from steel wit...

Mini bootlid inner frame, useful for racers using an aluminium boot skin.

Complete set of R/H and L/H metal window frames for Mini Traveller, Countryman and estate models. All in part sections requiring assembly, with corner section inserts to reinforce 4 main strips, plus 8 fitting studs per side.

This is the onl...

Stainless steel stud for original production factory fitted sports pack arches.

These use FN105047 nuts.

New genuine arches now have an upgraded threaded brass insert and now use a stud ZUA000250.

Fluted type equivalent of GZF105A. This is equivalent

design of CZH4316 which was fitted between mini special black arches. Sold per side.

Large blanking grommet for the Clubman inner wings, 1.5".

MkI aluminium boot lid "skin only" panel. This panel is produced off the original tooling, ensuring good panel fit and integrity. Following the pressing of the panel it is hand finished by Heritage craftsmen, to ensure the highest panel quality.

Captive nut plate that sits behind the damper bracket on the inner wing/bulkhead to attach the damper brackets. 2 PER SIDE.

The gasket that sits behind the door stiker on all wind up window type minis

on the B post.

MK3 Door & boot handle fitting kit, including original type screws, star washers and gaskets.

Metal floor plug as per original with rubber seal.



For use in 1" hole.

Non Genuine R/H lamp capping repair panel for the Mini Pick-Up.

The rear lamp panel is also available as 14A7557