(¥0) £0.15 exc vat
(¥0) £0.18 inc vat
In stock
(¥0) £0.15 exc vat
(¥0) £0.18 inc vat
In stockRecommended usage As Required x GHF1500 to fit one mini.
The clips that hold the seat squab vinyl to the frame on front seats and the headlining. These clips are available seperately as GHF1500.
Seat front base foam replacement. Moulded foam base and only one available solely from us, has been used on 1993 to 2000 cars. Made from sample from Rover of HGA100840
Static 3 point fixing front seatbelt with the female fixing on a stem.
3 point automatic rear seat belt. These seat belts do not use the standard C post nor the MPI fixing in the rear pocket. They require the fitting of the real on to the parcel shelf. These seat belts will work for all minis up to 1996
<...
3 point automatic rear seat belt. These seat belts do not use the standard C post nor the MPI fixing in the rear pocket. They require the fitting of the real on to the parcel shelf. These seat belts will work for all minis up to 1996.
...
Auto retractable seat belt kit. Sold per seat. The manufacturer states that these belts are direct replacements for the pre tensioner types fitted in Europe.
It will arrest the wearer within the same tolerances without a need for a...
Auto retractable seat belt kit. Sold per seat. The manufacturer states that these belts are direct replacements for the inertia reel type fitted from 1976 including the later pre tensioner type. Not suitable for MK1/2 saloons and vans/pickups due to...
FIA spec anchor plate for eye bolts, used when fitting harnesses. Sold individually, 7/16 UNF 65x65x3mm.
Front seat squab foam.This squab foam can be used for most models from 1980 to 1992/93 seat with single post head rest. C708 is the diaphragm for this.
This squab was used exclusively on minis 1985-1992 before the introduction o...
Front seat base foam.This cushion can be used for most models with single pole headrest from 1985-92 before the introduction of moulded seats. It is approx. 2" thick with raised sides and deeper version of SF3010 which it replaced to giv...
Clip for underside of front floor(3 per side) 6 in total fitted to 90
Eye bolt for harness mounting. sold individually, 7/16 UNF.
This is the small plastic nut used to hold the fuel line protector shield on later cars, also used to hold the catalytic converter heat shield on, 4 required for each shield.
In 1993 the seat frames were changed and although the base frame looks very similar to earleir models, there is a difference in the shape. At this time the seat diaphragm was changed to a special rubber/woven design known as the "Suisiara" model. The...
MODERN TYPE FOAM CUSHION CUT PRECISELY TO SHAPE READY TO RECEIVE NEW SEAT COVER.FOAM IS READY TO ACCEPT NEW SEAT COVER WHICH IS GLUED TO THE TOP SURFACE, THEN THE SEAT SKIRTS ARE TURNED OVER THE EDGES AND AGAIN GLUED IN PLACE. SUGGEST CHEMICAL BASED ...
Fitted to all saloons of this period. Shaped to the original design but made in modern day specification foam. The cushion is placed over the rear seat frame and the turned ends glued to follow the shape of the frame. The seat cover is then situated ...
Bracket on the crossmember that holds the seat.
2 required per seat.
Universal to fit many vehicles and definately the mini for all Cobra seats but beware if your original seats lock down to the floor as a safety requirement. These do not lock down. The MOT testers in the UK could fail you if yours were originally th...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.