(¥14) £14.40 exc vat
(¥17) £17.28 inc vat
(¥14) £14.40 exc vat
(¥17) £17.28 inc vat
The little spring that sits at the end of a spring loaded carb needle on late HS and all HIF carbs where applicable.
Our heavy duty throttle cable is superior in many ways.
A nylon interior ensures smooth operation. The outer cable is 32mm longer and inner is 95mm longer than the standard one.
Cable to carb bolt is ACC5062.
High quality klinger gasket that sits either side of the carb to manifold spacer on HIF44 type 1.75" carbs or HIF38. Now also sold as PKX100020EVA by Xpart
For a cheaper alternative see 88G429B sold singly.
Standard weight 4.5 ounce spring colour coded red for HIF type carbs only.
There is an optional heavier spring coloured yelow at 8oz.
Manifold stud 39mm long for all A series engines up to injection which use LYR10028 which is 6mm longer at 45mm.
Special extra long nuts were used on some manifolds. These nuts are about an inch long for easy reach and made of brass so they'll never corrode. Especially handy on the inner two studs on dual carb set-ups.
Sold singly and usually 2 used f...
A "must" on any performance engine this has 5/16" ends for competition engines where fuel lines have been increased in size. for standard 1/4" See PRO804 Supplied as per picture.
As an engine wears, the clearance between the valve stem and guide increases; as this gets beyond tolerances the car will tend to smoke under deceleration (when you take your foot off the throttle). Good valve stem seals will allow for greater wear b...