(¥11) £10.69 exc vat
(¥13) £12.83 inc vat
In stock
(¥11) £10.69 exc vat
(¥13) £12.83 inc vat
In stockRecommended usage 2 x RM6U to fit one mini.
This is a budget way of improving the stability of the front subframe leaving the rear mountings standard for quietness.
It only includes the 4 poly tower spacers and for the front of the front subframe 2 poly spacers and 2 metal washers.
Uses 2 Soft standard rubbers on the insides and the 2 Mauve poly on the outside.
HARD OUTERS / SOFT INNERS - STOPS BRAKE WEAVING.
Don't be confused as this special shore hardness set up was proven after 2 years of testing and is per...
The Mini's rear subframe is rubber mounted. Polyurethane (stiffer, much longer lasting) bushes are now available for the rear subframe trunions. Cars manufactured before 1976 used the same bush 2A5818(C-STR638) at the front and rear of the subframe, ...
Replacement spherical joint, these are known as the male type joints which are used on our lower arms or tie bars. Also known or referred to as rose joints as they were originally made and trade marked as such.
These spherical rod ends are also known as a Rose joint which is a registered trade mark. We use these ends on some of our weber carb linkage kits and anti roll bars. This is the male type threaded joint.
Mini Spares product,metal trunnion to hold the 2-2A5818MS bushes on the rear subframe.
Originally there were 4 of these trunnions on the subframe but in 1976 (MK4)the front 2 brackets were strenghened and enlarged to [link]21A2...
Mini spares product.In 1976 Rover started fitting this larger metal trunnion to the front of the rear subframe which only used one single large bush 21A2560.
2 required per car but sold singly
Front hydro to dry conversion kit less dampers owing to different customer requirements.
Conversion kit when converting rear subframe from hydrolastic to dry, includes everything except dry subframe radius arms and dampers owing to different customer requirments.
*** Please note: Radius arms are NOT included in this pa...
Replacement ball joint shims, comprising of 2x 003"(.076MM) shims, 2x 005"(.127MM) and 2 x 010"(.254MM).
This is the metal packing piece for the twin bolt pre 76 front dry subframe tower mount.
Hexagonal rod for adjusting hilos in traditional method--of course later day Hilos have other forms of adjustment also.
SOLD SINGLE
There are various options available from various sources to combine adjustability for camber and tracking of the rear suspension. Although functional they can be cumbersome to use, require specialist measuring equipment where frequent changes are req...
All models of the Mini use the same rear hub (this piece holds the rear wheel bearings). The Mini's rear wheel bearings are more than adequate, usually requiring only occasional repacking with grease. The weak link may be the cast iron hub; it is not...
Angled grease nipple for the upper arm on the front suspension of all Minis
importantly lubricates the upper arm spindle which so often gets neglected so check yours out and make sure this nipple is working properly. Also fits rear radius ar...
Mini Spares product from own original tooling since 1989.This small sheet metal panel mounts below the horizontal seam, covering the pivot pin of the R/H rear radius/trailing arm.
This shroud uses 14A7091 rubber plug not suppl...
The inner seal for the front hub uses a white plastic protection shield. The outer seal is GHS101. Sold individually.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.