($1.58) £1.58 exc vat
($1.90) £1.90 inc vat
In stock
($1.58) £1.58 exc vat
($1.90) £1.90 inc vat
In stockRecommended usage 1 x 5L1158 to fit one mini.
Battery rod with loop for cars with larger battery 8.55mm long.
Also see 5L1158 shorter version at 6cm long for Pre 1990 cars.
This item for post 1990 cars is the looped battery fixing rod with longer thread that fits o...
Battery bar and fitting kit for all pre 1990 cars whcih had the shorter battery bolts.
Battery bar and fitting kit for all pre 1990 cars whcih had the shorter battery bolts.
Small battery cable retaining bracket bolted at the front of the engine for pre engaged manual cars approx 1985 onwards.
universal battery clamp replacement with securing bolts and marked N
Your battery box 5L877 should be held in place by this rubber strap.
Universal post type battery earth strap with clamp type fitting and correct length for most alternatives of batteries fitted.
Universal battery clamp replacement with securing bolts and marked P.
They increased the length on this hook end bolt by 2cm in 1990. The shorter version @5.5cm is 5L1159 -this fits the front
Battery rod with open loop.
At 5.5cm long this is the open loop rod by the negative terminal which hooks into the battery box bracket. Also see YJJ100040 at 7.5cm lomg made ffor 1990 on cars with bigger battery.
Clip to retain the speedo cable to the bulkhead on pre 82 cars approx. This clip is also used to hold the loom to the inner wing on some cars.
Main wiring grommet that fits in the front parcel shelf. ID 12.5mm fits 35mm hole.
This is an ultra reliable universal hazard light module kit for any Mini that did not have hazard lights as standard (pre 76 cars).
A discreet but important safety upgrade for all classic vehicles.
Should you ne...
Mini Mk 4 998 oval centre dash,twin column stalks,rocker switches including rear fog and heated rear window,reverse lights and rear fog lamp is on headlamp circuit. Intertia starter. To go with AN145 rear loom.
mainly for 1980-1...
The smallest pre engaged starter motor available for the A series yet still producing 1.3KW of power! Ideal for race/tuned cars with high compression and cars that need more room for oil coolers etc. See GXE1004EVO for inertia.
Genuine Bosch lambda sensor, fitted to both the twin and single point injection cars and fitted in the same exhaust manifold shared by both cars. Be warned the cheaper non branded sensors cause lots of issues hence we only sell the Bosch version.
Electronic ignition conversion. For points type distributors, fixed or sliding. Negative earth only. Also, available for earlier 23/25D on Negative earth (LU142) or earlier 23/25D with Positive earth (LU142AP12).
ONLY use GCL217 coil for bal...
Also known as the idle air control valve (IACV). Bolts on the side of the injection body housing to control engine idle speed and air flow from cold start up. The blue socket loom cap fits this unit. This is part of MLZ100090. After fitt...
Sports coil for ballast resistor type ignition.
Best internal parts tested and another intermotor top product.
Its not the name on the outside but whats on the inside which matters.
Original type coil bracket 12G29...
Pop rivet for fixing the headlamp bowl to the wing. Great for MS14 metal bowl but be careful if using on plastic bowls
Pre A Plus Electronic Ignition distributor with vac unit, modified to our specification in the UK to give best performance on any minis with std to 276 camshaft profile.
Brand New distributor complete with electronic conversion already fitt...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.