($19.50) £19.50 exc vat
($23.40) £23.40 inc vat
In stock
($19.50) £19.50 exc vat
($23.40) £23.40 inc vat
In stockRecommended usage 1 x BMP103 to fit one mini.
The front bumper of your Mini should be mounted to this simple 'L' bracket that should in turn be spot welded to the lower edge of your front panel. Often damaged in accidents with the bumper. If you replace the entire front panel of the Mini it incl...
Boot hinge gaskets and fittings for original type hinges
Complete car set of rear sliding window runners for Mini Estate and Countryman models.
High quality non genuine door check strap for MK3 cars with wind up window doors (use with retaining pin CLZ412). Beware there are cheap copies on the market that are poor quality and when fitted to our cars did not function correctly!
Floor pan for Mini van/estate with no x member for remote change gearbox. Non Genuine. For saloon see 14A6491
picture is just to show what you get but bulge on centre tunnel for starter button appears to be on wrong side as this...
This is small plate that welds into the later lower dash rails to convert them to mk1 size for people who want early switches in a late car.
The gasket that sits behind the door stiker on all wind up window type minis
on the B post.
MK3 Door & boot handle fitting kit, including original type screws, star washers and gaskets.
Metal floor plug as per original with rubber seal.
For use in 1" hole.
Non genuine rear companion bin for external hinge cars. These are supplied without the ash try mount.
Non genuine rear companion bin for external hinge cars. These are supplied without the ash try mount.
Complete set of bolts to mount the front subframe on all post 76 single bolt subframes less the large tower bolts and towing eye, enough fixings are supplied for those who wish not to use a towing eye.
Protective wax Rover introduced to protect newly drilled holes in bodywork for such things as Badges. A small 10ml sachet only but ideal for any new holes drilled for wiring,screws and badges where metal could be left bare.
Thses were suppli...
Tank strap bracket welded to the rear of the boot floor which the single diagonal tank strap 21A2838 attaches to.
Angled spacer washer for Mk1/2 external door hinge cars for the upper hinge
Van R/H full length half floor. You can spend hours cutting out rust and patching holes, but why bother? These reproduction floor pans extend the full width and length -plain pressed floor with indents but no carpet brackets or lugs underneath.
Van L/H full length half floor. You can spend hours cutting out rust and patching holes, but why bother? These reproduction floor pans extend the full width and length-plain pressed floor with indents but no carpet brackets or lugs underneath
Body side rear lower w/arch to rear section of bodyside repair R/H. 220mm tall.
non genuine L/H outer MK3 door skin lower few inches repair section.
not as good a fit or looking as the genuine complete skinCZH3301
non genuine R/H outer MK3 door skin lower few inches repair section.
not as good a fit or looking as the genuine complete skin CZH3301
Non genuine L/H saloon inner sill. Only made as an after market replacement as no genuine part was ever available seperately. Best one on the market for a comlplete inner sill replacement panel. With carpet fix brackets.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.