BALL JOINT KIT MINI-GENUINE MINI SPARES PART

Genuine Minispares approved joints that we have supplied since 2004-

Beware of spurious products on the market as these are a safety critical part.

BEWARE OF CURRENT SO CALLED GENUINE ITEMS AS THEY ARE NOT FIT FOR PURPOSE.

...

($9.30) £9.30 exc vat

($11.16) £11.16 inc vat

MAINTENANCE FREE BALL JOINTS - CAR SET

C-GSJ166KIT

Set of 4 High quality Japanese sealed ball joints.

Developed and tested over a period of three years, the original concept was to manufacture a high quality product, similar to those used on modern vehicles. Unlike the current des...

($220.40) £220.40 exc vat

($264.48) £264.48 inc vat

MAINTENANCE FREE BALL JOINTS - CAR SET

C-GSJ166KIT

Set of 4 High quality Japanese sealed ball joints.

Developed and tested over a period of three years, the original concept was to manufacture a high quality product, similar to those used on modern vehicles. Unlike the current des...

($220.40) £220.40 exc vat

($264.48) £264.48 inc vat

SUSPENSION KNUCKLE JOINT WITH POLY BOOT GAITER

GSV1118EVO

Genuine Mini Spares UK made complete joint with the following specifications,

correct dimensions and shape of pin and ball in EN24T, using correct spec grease,

genuine original shape cup using correct material (21A423MS...

($4.88) £4.88 exc vat

($5.86) £5.86 inc vat

SUSPENSION KNUCKLE FRONT ONLY 1990 ON WITH POLY BO...

GSV1264EVO

Genuine Mini Spares UK made joints are complete with the following specifications, correct dimensions and shape metal knuckle in EN24T, with the genuine cup made in original material and correct shape (21A423MS) and an upgraded poly boot...

($6.75) £6.75 exc vat

($8.10) £8.10 inc vat

7/16 NUT FOR BALL JOINT high tensile

FNZ507

High tensile nut for swivel pins - supplied in kits GSJ166MS and GSJ166.

($0.61) £0.61 exc vat

($0.73) £0.73 inc vat

ROAD RALLY RUBBER CONE SPRING - RED SPOT

C-STR687

Genuine Mini Spares product ideal for road use for maximum performance, where other examples available tail off as they get worked and heat up.

Hilos will be required to enable fitment as they are taller but FAM3968EVO are a str...

($49.60) £49.60 exc vat

($59.52) £59.52 inc vat

2.0° NEGATIVE CAMBER LOWER ARMS

C-AJJ3364A

Lower suspension arms to give 2.0 extra degrees of negative camber. Stamped with 2.0 Sold in pairs only.

General:See also c-AJJ3360 fully adjustable arms

Negative camber lower arms are specifically forged in different degrees to...

($52.00) £52.00 exc vat

($62.40) £62.40 inc vat

GREASE NIPPLE TOP ARM (45°)

UHN445

Angled grease nipple for the upper arm on the front suspension of all Minis

importantly lubricates the upper arm spindle which so often gets neglected so check yours out and make sure this nipple is working properly. Also fits rear radius ar...

($0.85) £0.85 exc vat

($1.02) £1.02 inc vat

LOWER ARM BUSH UPGRADE BLACK POLY TYPE

21A1882MS

Lower arm top hat bush in poly to fit all lower arms with twin taper as standard from 1965. Mini Spares have upped the game once again with these superbly finished bushes which surpass anything on the market. Fitted with a metal bush insert these are...

($1.50) £1.50 exc vat

($1.80) £1.80 inc vat

LOWER ARM BUSH SET RACE GRADE WITH CORRECTED GEOME...

C-STR631

A must-when the castor and camber angles are changed or whenever the geometry of the car is set up you will require these bushes. They are good for cars with up to 3.5 degrees of castor angle.

From November 2003 they have been made from a s...

($11.00) £11.00 exc vat

($13.20) £13.20 inc vat

SUBFRAME MOUNTING FRONT ALLOY TEARDROP FOR FRONT (...

C-STR641

To compliment the top alloy blocks (C-STR640), those troublesome front rubber mountings can be replaced by alloy cast mountings which will not break and further enhance roadholding. These are for the front of the front subframe on vehicles built from...

($17.00) £17.00 exc vat

($20.40) £20.40 inc vat

TIE BAR BUSH KIT FOR ROAD/RALLY RACE (4 BUSHES)

C-STR627

Uses 2 Soft standard rubbers on the insides and the 2 Mauve poly on the outside.

HARD OUTERS / SOFT INNERS - STOPS BRAKE WEAVING.

Don't be confused as this special shore hardness set up was proven after 2 years of testing and is per...

($8.22) £8.22 exc vat

($9.86) £9.86 inc vat

SUSPENSION ONE PAIR OF ADJUSTABLE TRUMPETS/HILOS

HILO

Each Hi-Lo Suspension Kit Includes one pair of Hi-Lo trumpets and nylon knuckle cups which will fit front or rear, but you will need the sleeved rods HILO-01 to enable fitment to the rears. For a car set you require 2 HILO k...

($37.65) £37.65 exc vat

($45.18) £45.18 inc vat

UPPER ARM REPAIR KIT

MSK001

Mini Spares own to original drawing specifications with heat treatment correctly applied where appropiate.Lack of proper maintenance (grease) will make the pivot shaft and/or bearings wear that much faster. In severe cases the shaft may rust to the b...

($12.81) £12.81 exc vat

($15.37) £15.37 inc vat

SPLIT PIN FOR OUTER CV JOINT (DISC BRAKES ONLY)

GHF510

Split pin for the larger size CV joint as fitted to disc brakes. This pin is usually supplied in our normal stock bearing kits. Sold individually.

this will also fit the nut for the rubber cross drive coupling on the gearbox

($0.11) £0.11 exc vat

($0.13) £0.13 inc vat

SHOCK ABSORBER TO UPPER ARM UPGRADED PIN

C-AJJ3361

Upgraded, lower EN8 damper pin. 3/8"unf. Sold singly

Especially useful for competion cars or street cars with lowered suspension.

Its quite a good idea to change these if they are corroded to give a better seating for your dampers.<...

($9.08) £9.08 exc vat

($10.90) £10.90 inc vat

FAST ROAD LOWER ARM BUSH SET

C-STR632

Mini Spares product UK made especially for use when geometry has been changed, such as fitting adjustable tie rods or lower arms, or on any cars with corrected castor angles.

Set of 4 bushes.

These metal sleeved bushes are specially...

($10.91) £10.91 exc vat

($13.09) £13.09 inc vat

SUSPENSION KNUCKLE JOINT

GSV1118MS

See-Mini Spares own UK made GSV1118EVO first for a correct upgraded version with an improved poly gaiter and original genuine cup on EN24T pin with correct shape ball for a great value item.

Mini Spares own part will out surviv...

($3.05) £3.05 exc vat

($3.66) £3.66 inc vat

GREASE NIPPLE SWIVEL PINS - STRAIGHT (2 required p...

LN10051

Always check these grease nipples on your front hubs are working as they are very important. These two swivel pin grease nipples are the same, upper and lower. Also used on the rear radius arms. Sold individually.

these are top quality greas...

($0.95) £0.95 exc vat

($1.14) £1.14 inc vat

1.5° NEGATIVE CAMBER LOWER ARMS

C-AJJ3364

Sold in pairs only.

These arms will give an extra 1.5 degrees extra negative camber over what the standard arms give on your car. To correct all variations of incorrect geometry found on the mini we have produced a pair of on car adjustable ...

($45.00) £45.00 exc vat

($54.00) £54.00 inc vat

LONGER COMPETITION TRACK ROD END

C-AJJ1572

Longer track rod end for running with negative camber, gives an extra 5mm of adjustment approximately over the standard item. Has consistent thread pattern and perfect design to our requirements to fits all known racks and classed as a competition tr...

($7.92) £7.92 exc vat

($9.50) £9.50 inc vat