BOLT 3/8UNF.3 INCH
GFK5198

($0.90) £0.90 exc vat

($1.08) £1.08 inc vat

In stockIn stock

($0.90) £0.90 exc vat

($1.08) £1.08 inc vat

In stockIn stock

Recommended usage 1 x GFK5198 to fit one mini.

People also bought products

5/16" UNF THREAD 2 1/2" LONG bolt commonly used for 21A2838 petrol tank strap

Stainless steel version of GFK5184, worth keeping a few spare as they are one of the most common bolts fitted to the Mini.

Stainless steel version of GFK5185, worth keeping a few spare as they are one of the most common bolts fitted to the Mini.

Clutch housing bolt to engine long 5/16" UNC 1.75" long Fitted ffrom 1985 for clutch housing instead of 22A152 stud

Clutch housing bolt to engine long 5/16" UNF 1.75" long with tuflock patch to secure. Earlier bolts less tuflock are {link]BH605141{/link}

Remote type gearboxes had four UNC bolts holding the long alloy housing to the differential case. These are the shorter two, 3/8"unc 1"long. The longer two are ZCS628.

Also the bolt to hold the starter motor.

Also the bolt for the [...

There are 3 of these bolts fitted -1.75"long 5/16"UNF bolt ALTERNATIVE DAM7758.

Also used as longer bolt for water pump.

Also for the 21A1091 heavy duty tie rods on front suspension.

Bolt for CHM85 differential side cover. 1" long UNC useful for pre verto slave cylinder and starter bolt. Also 12A361 engine mounting bracket to alloy case.

Front subframe to front teardrop mounting, clutch case to block.

Engine mounting to subframe - easier to use than the GFK5184 - 3/4" long

Bolt used in our anti roll bar kit and for holding plate on speedo drive housing on gearbox

This 5/8unf steel hexagonal head blanking plug was made for the inlet manifolds where the servo union can be fitted, plus blanking off the thermal transmitter hole under the thermostat. Uses 1B3664 washer ----------please note this will ...

Bolt for the overider to lock plate at the back of the overider to secure it against the bumper.

Also has been used for the rear subframe trunnion 2A5819/21A2558.

Also used for the short water pump bolt.

Replacement screw for the clubman indicator/side lamp lens. 28mm long. Plus fog lamp lens. New stock is threaded along the whole length and made from stainless steel.

Popular bumper to overider bar bolt but also fits oil pumps and gearbox cases. 1.5" long bolt.

Following are oil pump bolt lengths.

GFK5170 is 1.5" long Holburn Eaton and Sureflow.

BH604131 is 1.6250".

Assorted high tensile UNF setscrews with approx qty:



30-3/16"x1"

25-1/4"x3/4"

20-1/4"x1"

15-1/4"x1.5"

25-5/16"x3/4"

15-5/16"x1"

10-5/16"x1.5"

10-3/8"x1"