£52.50 exc vat
£63.00 inc vat
In stock
£52.50 exc vat
£63.00 inc vat
In stockRecommended usage 1 x 18G8938 to fit one mini.
Seal for between the brake servo and master cylinder, fits all late 1988 onwards vehicles where the master cylinder was mounted directly to the servo unit.
Replacement rubber grommet for the servo vacuum hose for the 1992 onwards brake servo (GSM119)
Special formulated hose for brake servos and engine emmission breathers sold in a 22 inch length. 3/8" inner bore.
From 1989 minis which have the brake servo built into the master cylinder and it is very difficult to work in the engine bay, especialy clutch changes because of the extra room taken up by this dual cylinder. By replacing the 2 metal brake pipes from...
A pair of black painted servo brackets for MK1 cars or when using the 21A1293 servo.
Genuine AP product-HOSE FITTING EITHER END in-line brake servo valve which is essential if you do not have the correct U shape section formed in the servo hose to stop petrol contaminating your servo. Not supplied in any kit it is an important part. ...
Mini Spares copy of original AP Lockheed Mk1/Mk2 "S"servo which have not been available for decades. Using the correct cast iron body it is dimensionally the same as the 5.5 Lockheed type 112756 as fitted to the original Cooper S Mk1/2.
(Thi...
now in a plastic housing this is the air valve for the single brake line servo
which was not always available by the factory but has been made for us again by
AP Braking
This kit is useful for mini based kit cars, sprites and morris minors but are parts included in the SEN43 complete servo kit.
Servo repair Kit for all models after 1989/90 where the servo is buit into the master cylinder. The gaiter for the brake pedal is NAM8567
This Servo is the integral part of the master cylinder as fitted on the production line of Rover from October 1988 on. Includes NAM8569 and NAM8570.
See NAM8570 for seal to master cylinder.
Genuine AP Original Mk3 Cooper S and 1275GT servo is now supplied as this universal kit for single line brake systems. This kit replaces the servo originally sold on its own at no greater expense, but the brackets are universal for fitment to any veh...
Rubber gaiter to keep debris from entering the drum via the backplate handbrake lever SMN10005. Sold singly per backplate, 2 required per car.
Genuine AP Lockheed rubber boot
Set of 6 hoses, 4 front and 2 rear to fit the ERA turbo.
Braided brake and clutch hoses have a PTFE inner which helps to eliminate the spongy pedal feel under arduous conditions, and give greater efficiency. The outer braided st...
Mk1/2 in-line brake servo valve for 21A1293 servo. It is essential if you do not have the correct U shape section formed in the servo hose to stop petrol contaminating your servo. Not supplied in any kit it is an important part. If you ...
Master Cylinder repair kit for repairing the late GMC90376 master cylinder that was attached to the servo from 1995 until the end of production this kit uses a longer seal in conjunction with a nylon bearing. If your master cylinder has a drill hole ...
Road use pads but for performance use C-AHT223GREEN these are original size 2.375" which fit later 997 cooper- but if you have the very early small pad type, 2.125" wide for 997cc less split pin holes, these are nearly obsolete you can g...
Our favourite pads as the give less brake pad dust which destroys alloy wheels.
Very durable and great for most road usage. The green upgrade for fast street is C-8G8995GREEN.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.