£28.05 exc vat
£33.66 inc vat
In stock
£28.05 exc vat
£33.66 inc vat
In stockRecommended usage 1 x MSG12 to fit one mini.
For all rod change gearbox mechanism housings, this as un uprated poly bush replacement for the standard rubber bonded mount
The pin in the bottom of your gearbox that holds all the gearchange levers.
These parts are soiled but usable as they are used.
Quick release rod change gear coupling a direct replacement for the standard item, doing away with the troublesome roll pins. It comes complete with high quality quick release clips
Just because you have a rod-change gearbox doesn't mean you're immune from gearlever vibration. The ball on the end of the lever wears and is not seperately replaceable; replacing the lever is the answer.
The new improved KAD quickshift is a redesign of the original KAD stick incorporating many detail changes.
* Reverse is now selected by lifting a collar beneath the gear knob.
* Now supplied with an alloy gear knob.
...
Oversize cotton reel type mounting, sold singly 2 of these are required on the metal bracket that holds up the rod change gear linkage.
gearbox to engine steady rod for rod change geaboxes.1/2"longer than 998cc type to accomodate for the engine being further forward on 1275cc models from 1990 on.This is the rod with bends in and has a fork at one end and threaded at the other. First ...
This pin joins the gear change rod to the selector rod, behind the diff housing
case and is usually easier to remove when reverse is selected.In reverse gear the angle is easier for removal. This is a great time to fit the Mini Spares slick ...
Metal coupling sleeve on the rod change gear change shaft extension rod under the floor, which attaches to the gearbox and held on by RPS1416 roll pin. This attaches to the rod that goes to the gearlever housing to change gears.
This large rubber plug fits in the end of the remote control housing side enabling grease up of linkage etcetera.
Quick-shift kit for Rod Change shifters. (See C-22A1750 for remote shifters.)
By raising the pivot point on the shift lever, the amount of throw is reduced considerably. That means you get shorter, quicker shifts! Parts includ...
Quick-shift kit for Remote shifters only. (See C-22A1751/2 for Rod change.)
By raising the pivot point on the shift lever, the amount of throw is reduced considerably. That means you get shorter, quicker shifts! Parts included in the k...
Upgraded Viton version of ADU5738. Drive shaft oil seal or diff output shaft oil seal for all Mini's except Cooper S and early Automatics. 2 required per gearbox.
Idler gear conversion for straight cut drop gearsets only.
This set up is for A plus idler gearbox cases only and uses a single roller bearing centrally unlike the old timken conversion which had taper bearings either end.These gears are ba...
Evolution Straight cut 24 tooth input gear.
These gears are banded with 2 rings for identification.
Do not mix and match with other gears that have same teeth counts unless they have the same 2 identification bands
...
Evolution Straight cut 24 tooth 1275 primary gear.
Evolution Straight cut 23 tooth 1275 primary gear.
Ongoing development and investment of bringing parts up to date from yesturyear with current technology Mini Spares h...
Evolution Straight cut 22 tooth 1275 primary gear.
Evolution Straight cut 23 tooth 1275 primary gear.
Ongoing development and investment of bringing parts up to date from yesturyear with current technology ...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.