"O" ring that fits on the alloy sleeve in the anti oil leak kit where the rod change enters the gearbox. Also fits rod change driveshafts where pot joint butts up against the flange to stop splines rusting. Rover stopped fitting this seal on later 19...

Actually the concertina dust cover for the rod change oil seal to prevent road debris attacking the seal. See MSSK050 kit when undertaking this job.

This kit consists of one alloy sleeve with a groove on the outside to locate the O ring, the new "O" ring, a rod seal and a gaiter. To fit the kit simply remove the old gaiter if fitted and then the old oil seal. Fit the sleeve with the "O" ring fitt...

Upgraded Viton version of ADU5738. Drive shaft oil seal or diff output shaft oil seal for all Mini's except Cooper S and early Automatics. 2 required per gearbox.

Originally developed by Rover to cut down on warranty hourly costs on powertrain warranty repairs, by their main dealers.-Labour time allowed at Rover dealers for fitting this seal was 3.4 hours labour rate.

This is a special rigid seal and ...

Seal, Oil, flange type.

This kit consists of one alloy sleeve with a groove on the outside to locate the O ring, the new "O" ring, a rod seal and a gaiter. To fit the kit simply remove the old gaiter if fitted and then the old oil seal. Fit the sleeve with the "O" ring fitt...

Front main (half moon) black seal for all transverse engines. This is the flexible item as fitted originally after replacing the early red type that leaked.

See [link]CAM6548{/link] for the rigid seal designed by Rover for all their warran...

If you still have the original factory oil pick up pipe in your gearbox and not the C-AHT54 special pick up this is the oil seal that fits the pipe where it goes into the wire mesh strainer - this seal is not in gearbox gasket sets.

The gasket with the oil suction seal hole fits every mini gearbox case and the other two are for the different case shapes, one for 3 synchro case and one for 4 synchro gearbox case, so choose the one you require. For latest spec Klinger gasket set u...

Genuine gearbox gasket for the large alloy end cover which also houses the speedo drive pinion for all years of mini. The small gasket on the alloy housing with 2 bolt holes is GUG705564GM and the small pear shaped speedo housing gasket ...

Genuine Mini Spares green and black upgraded Klinger gasket set. 3 pieces



Has the extra front gasket required for 3 synchro case use

Gearbox oil strainer to gearbox internal case gasket and also used on the C-AHT54 special oil pick up pipe. One also sits on the outer plate held onto the gearbox outer casing by 2 screws.