These wings have the original round headlamp hole which is okay unless you have the dipping headlamps fitted to some export models and MPI cars--
1997-2000 cars need to use ASB360009 which has the recess for the headlamp adjusti...
non genuine boot hinge panel repair piece
this panel is just longer then the 3 central bumper holes and has the boot hinge holes plus the part of the body that the boot hinge seal sits on making this a perfect rust or accident repair panel. ...
Drip rail fitted under the roof on either side of cars built before 1980
The rear doors of the Mini Van and Wagon are the same except on the Woodie were a wood frame is screwed to the sheet metal. The door has a inner and outer skin and should have drain holes in the bottom. When these plug up the resulting rust always ...
For Minis with sliding windows and external door hinges These NON genuine L/H outer A panels fit over the extra inner panel which have brackets on to reinforce the exterior hinges. If the outside one is rotten you can guarantee t...
Aftermarket wings do the job at a fraction of the cost of the originals. This left front wing for the Mini will fit all MKI, II, III & IV. A slight difference exits between the early and the later models as to headlamp mounting holes. These reproduct...
This simple panel on the traveller or van is the first to go in a rear end accident and also can have rust problems. If you are fixing a wagon or van you probably need this piece-it makes the whole job easier.
For Minis with sliding windows and external door hinges. These NON genuine R/H outer A panels fit over the extra inner panel which have brackets on to reinforce the exterior hinges. If the outside one is rotten you can guarantee ...
THIS PANEL PROTECTS THE UNDERSIDE OF THE WINDSCREEN VALANCE UNDER THE FRONT WING SECTION also fitted on the inner wing panel 14A8346/7
Fits round tunnel cars. Approximate location of the vertical, forward wall is 17.5 - 17.75 inches back from the crease in the floor where the floor bends upward under the pedals. The forward wall lines up just forward of the front portion of the exte...
closing plate against the bodyside in the base of the r/h rear companion/glove box now has a square pressing hole for later models
Genuine R/H rear quarter outer skin from the B post back for MK3 cars with wind up windows.From below the rear side window down, including the lip that the rear quarter light window seal sits on but does not include the inner stifener waist rail [lin...
Metal backing plate rear number plate for vans/estates, has location holes for wires of 2 rear number plate lamps at either end - will only take original size number plates as it is only 4.25" high but about 25.25" long to accept the lamps either end...
Genuine panel that has the holes for wipers and jets with only a few inches of pillar which is basically the area that rots. Also referred to as the windscreen scuttle lower panel. Fitting the genuine type ensures you should get a better windscreen a...
the A post repair panel with hole for coureousy light swith about 8" of metal below and above the hole. External hinge type cars MK1/2 and vans etc.
2-3" lower section of body section
from A post to rear wheel arch including the vital door step sill profile that rusts plus the horizontal edge that the chrome trim sits on
For cars with internal door hinges and wind up windows
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.