2-3" lower section of internal door hinge type Clubman Estate body section
from A post to rear wheel arch including the vital door step sill profile that rusts plus the horizontal edge that the chrome trim sits on-for cars with internal hin...
See ALA5661MS for an upgraded thicker and best fitting aftermarket L/H A panel-all the local bodyshops fit this.
Known as an A panel this is for all wind up widow type cars with internal door hinges and is single skin as opposse...
Genuine repair panel which is about 2.52 high from bumper mounting seam and
includes hinge holes and lower part of bootlid surround channel. Full width panel for any saloon.
Closing plate against the bodyside in the base of the l/h rear companion/glove box now has a square pressing hole for later models
Front number plate to the old original classic size 3.75"high by about 20.5"long overall. If you prefer a stainless steel plate to the later current legal size see 8B12390 which is 5.5" high and one inch longer
non genuine oversill MK1/2 van floor profile L/H with 4 flute vents see MS58L for 6 flute vents
the rear lower non genuine corner section of the rear valance on vans.estates.travellers and pick ups R/H---See MS23 for centre section
1970 on, cars with internal hinges and wind up windows
This repair R/H panel has holes for the hinges on A post and overlaps 6" at top tapering to 9" at bottom (150mm-215mm) onto the wheel arch section.
Also has the first section of...
2-3" lower section of internal door hinge Clubman Estate body section
from A post to rear wheel arch including the vital door step sill profile that rusts plus the horizontal edge that the chrome trim sits on-for cars with internal hinge ty...
Inner front R/H wing with the A panel and door stiffener check strap panel attached for ease of fitment and alignment. Always check the bonnet prop bracket location as they changed.
Inner l/h wing with large fan hole from 1991-96. This panel is available with the A panel fitted for ease of fitment as ABD36005
Was ABD36009 but that did not have the stiffener plate for the damper bracket fitted which was diff...
Genuine rear luggage pocket but the later shape without ash trays but a mounting recess point for inertia seat belt, this is the nearside l/h.
Genuine front panel fits all pre rubber mounted subframe cars .
The early pre 1964 Mk1 had different shape lower valance without cut aways under the bumper apron but this genuine panel will fit all.
There is a good aftermaket panel...
Floor pan front to rear for the right hand side only to the correct floor shape before 1990-1 rib design change---ideal for MK1/2 restoration with original 4 flute indentation. This has the carpet stud brackets plus underside slinger bracket and mult...
floor pan front to rear for the left hand side only to the correct floor shape before 1990-1 rib design change---ideal for MK1/2 restoration with original 4 flute indentation. This has the carpet stud brackets plus underside slinger bracket and mul...
R/H Inner hinge type A post repair panel with fittings holes mini, MK3.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.