This panel has mounting holes for later models facia crash panel. These holes will require blanking for true originality on earlier models without the facia pad
THIS PANEL PROTECTS THE UNDERSIDE OF THE WINDSCREEN VALANCE UNDER THE FRONT WING SECTION also fitted on the inner wing panel 14A8346/7
rear subframe mounting stiffener L/H repair bracket with holes for subframe mounting and attaches to wheel arch Fits on ALA8623
Non Genuine for the Pick-up and Van with a slat type fixed grille as a trademark for Mini commercial type vehicles originality.
This good reproduction is the only panel available to allow you to restore it easily.It is a modified saloon pan...
2-3" lower section of body section
from A post to rear wheel arch including the vital door step sill profile that rusts plus the horizontal edge that the chrome trim sits on-for cars with hinge tye doors
The rear doors of the Mini Van and Wagon are the same except on the Woodie were a wood frame is screwed to the sheet metal. The door has a inner and outer skin and should have drain holes in the bottom. When these plug up the resulting rust always ...
the rear lower NON genuine corner section of the rear valance on vans.estates.travellers and pick ups L/H --See MS23 for centre section
1970 on, cars with internal hinges and wind up windows
This repair panel has holes for the hinges on A post and overlaps 3.5"(85mm)onto the wheel arch section
If your rusted old headlight bucket is getting to you, don't waste time trying to salvage it when new metal reproduction metal buckets are AVAILABLE.
With a headlamp rim fixing bracket 37H7421 attached
Whether you are ...
1970 on, cars with internal hinges and wind up windows
This repair panel has holes for the hinges on A post and overlaps 3.5"(85mm)onto the wheel arch section of inner wing
Cooper S Right Hand Tank. Our new perfect fit and shape tank is now in stock. No unsightly "stretch" marks as seen on other tanks that are available, this is a perfect authentic item we are proud of. Approx 5.5 gallon.
See MS82 ...
You can spend hours cutting out rust and patching holes, but why bother? These reproduction floor pans extend the full width with vertical flanges for easy installation, and fairly well represent the original stamping. They have added metal to includ...
This early front (nose) panel will fit any Mini manufactured before 1976. It is probably easier to replace the entire panel than to repair a damaged one, especially if it's been hit more than once! Later Minis with rubber mounted subframes, use panel...
NON genuine 8"wide right hand outer sill for the van/pick up and estate range with MK3 square pressings. No genuine wide panel is available but see 14A9026/7 for 4" wide panel which actually covers only 2.5" of actual lower floor pan whereas the non ...
Non genuine body side skin from door back and below window line for the right hand side
These small repair panels (MS24L for left, MS24R for right) are for the Mini boot floor area around the shock towers.
Non Genuine metal battery box. always going rusty owing to the location of where it is fitted. Requires welding in place and preferably painted or a protective coat. Remember to check if the battery cover, strap and clips need changing. Popular afte...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.