the rear lower non genuine corner section of the rear valance on vans.estates.travellers and pick ups R/H---See MS23 for centre section
Genuine rear luggage pocket but the later shape without ash trays but a mounting recess point for inertia seat belt, this is the nearside l/h.
Floor pan front to rear for the right hand side only to the correct floor shape before 1990-1 rib design change---ideal for MK1/2 restoration with original 4 flute indentation. This has the carpet stud brackets plus underside slinger bracket and mult...
floor pan front to rear for the left hand side only to the correct floor shape before 1990-1 rib design change---ideal for MK1/2 restoration with original 4 flute indentation. This has the carpet stud brackets plus underside slinger bracket and mul...
rear subframe mounting stiffener L/H repair bracket with holes for subframe mounting and attaches to wheel arch Fits on ALA8623
The rear doors of the Mini Van and Wagon are the same except on the Woodie were a wood frame is screwed to the sheet metal. The door has a inner and outer skin and should have drain holes in the bottom. When these plug up the resulting rust always ...
the rear lower NON genuine corner section of the rear valance on vans.estates.travellers and pick ups L/H --See MS23 for centre section
Non genuine body side skin from door back and below window line for the right hand side
Non Genuine metal battery box. always going rusty owing to the location of where it is fitted. Requires welding in place and preferably painted or a protective coat. Remember to check if the battery cover, strap and clips need changing. Popular afte...
Genuine L/H rear quarter outer skin from the B post back for 1970 on wind up window door cars only.From below the rear side window down, including the lip that the rear quarter light window seal sits on but does not include the inner stifener waist r...
genuine rear lower back panel for MK2/3 on, which goes up as far as lower edge of backlight seal ridge
Non genuine body side skin from door back and below window line for the left hand side
This rear bulkhead panel is the actual panel the rear passengers back rest against where the upright seat squab is positioned. Not always carried in stock but usually available to special order--this is done to the last factory pressing with the loca...
Commercial Mini floor extension
It is an essential part for the correct restoration of all the longer wheelbase mini derivatives. From the original tooling.
this r/h waist rail is alreday fitted to a new bodyside CZH430 .
It acts as a stifener on the inside of the bodyside just below the rear side window for strengthening between rear seat pan and B post
the left hand waist rail that is supplied on a new bodyside from us.
Acts as a stiffener on the inside of the bodyside between the rear seat pan and the B post just under the rear opening side window