Assorted high tensile UNF setscrews with approx qty:
30-3/16"x1"
25-1/4"x3/4"
20-1/4"x1"
15-1/4"x1.5"
25-5/16"x3/4"
15-5/16"x1"
10-5/16"x1.5"
10-3/8"x1"
Popular bumper to overider bar bolt but also fits oil pumps and gearbox cases. 1.5" long bolt.
Following are oil pump bolt lengths.
GFK5170 is 1.5" long Holburn Eaton and Sureflow.
BH604131 is 1.6250".
Large headed screw for safety. Short for securing the van petrol tank 21A291.3/4" long
There are 2 of these long high tensile bolts in each tower of the front subframe on pre 1976 cars to hold it in place on the bulkhead. Do not forget to renew the locktab 21A1470 on these bolts. Not suitable for hydrolastic cars - see [l...
Replacement screw for the clubman indicator/side lamp lens. 28mm long. Plus fog lamp lens. New stock is threaded along the whole length and made from stainless steel.
Two of these long UNC bolts are required to hold the alloy remote control to the gearbox diff housing on Remote type gearboxes. The two short UNC bolts are GFK5240.
This 5/8unf steel hexagonal head blanking plug was made for the inlet manifolds where the servo union can be fitted, plus blanking off the thermal transmitter hole under the thermostat. Uses 1B3664 washer ----------please note this will ...
Bolt used in our anti roll bar kit and for holding plate on speedo drive housing on gearbox
Front subframe to front teardrop mounting, clutch case to block.
Engine mounting to subframe - easier to use than the GFK5184 - 3/4" long