($13.08) £13.08 exc vat
($15.70) £15.70 inc vat
In stock
Check straps matched seat colours or outer main seat colour on two tone types
ALE1221 Black
14E8403 Cumulus grey-light grey-darker than Dove Grey trim
14E4288 Powder Blue
14E4289 Tartan Red
14E42901221 Dark Grey as used on seat outers
14E4291 Porcelain Green
($13.08) £13.08 exc vat
($15.70) £15.70 inc vat
In stockRecommended usage 2 x 14E4289 to fit one mini.
Screw for either end of the material check strap on MK1/2/van/pickup minis with external hinges. The head of this screw is chromed for a superior finish.
This plate has recessed holes in for the check strap screws.
2 per door are required and these are only for cars with external hinges that had the material check strap as per MK1/2 and vans.
The larger check strap bracket on the body that has a curved section. Shown as black in the picture. One per door required.
The door stiffener plate for the check strap on mk1/2 doors with external hinges
one per door required.
Complete fitting kit for the door check straps on all Minis fitted with external hinges.
The chrome moulding to fit the door bin on first 80 thousand MK1 minis with extra length tag with screw hole for location.
This is held on by screws but a single sided prong clips ADH3809 can be used in the centre - beware other...
MK1/2 interior door handle with screw and washer.
This solid "spoon" handle is brittle and easily broken.
These are the original shape as sold under the Unipart label, not the later Rover bagged item which was a reproduction with d...
Metal chromed old type classic handle revived for use on MG variants and then a fashion item on minis. On later cars CMZ312 screw might be required which has a smaller diameter head and longer thread. Length 90mm.
Original type MK1/2 door strap in Dark grey(darker than cumulus grey and dove grey was slightly lighter again)
Check straps matched seat colours or outer main seat colour on two tone types
ALE1221 Black
[link]1...
This 10 piece handle set is exactly the same kit as sold by every other mini specialist is in bright alloy (not polished alloy as per our other superior kit MSA1129) and consists of two of each of the following, door openers, window winders and their...
This plastic handle fitted any wind up window cars up to the introduction of the twin points, which then changed and the handle fitted from 1996 on is now obsolete.
If you drive your MINI/MGB often then you know that the standard plastic window winder handles are prone to breaking. These chrome metal handles are somewhat stronger and look great alongside the other chrome trim in the car's interior. Next time ...
Mk1 1962 on grey headlining that fitted on 2 hoop type frames whereas the Mk3 had individual rods. This is for Mk1 saloons only, see 5D4085 for cream crackle. (Does not include the framework).
Mini Pickups had a one piece headlining frame with the canopy glued and stapled to it. Cream Crackle was used on early models and the light grey was used during the 1970's. These frames are no longer available, so make sure you keep the frame safe if...
Black door pocket liner for the R/H door which has sliding windows and external hinges
Black door pocket liner for the L/H door which has sliding windows and external hinges
White with mirror aftermarket sun visor for Mk3 models from 1977 -92 which were thinner than pre December 1965 for safety crash requirements. Check out the special clips to hold these visors as they are sold seperately in car sets only as [link]SV202...
Plain white with white backing aftermarket sun visor as fitted to Mk3 models 1977-92 which were thinner than Mk1 for safety crushing requirements. Although not standard for earlier models will fit cars from December 1965. Check out the special clips ...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.