SPI TO HIF44 CARB CONVERSION KIT
C-STN23

($1,424.57) £1.424.57 exc vat

($1,709.48) £1.709.48 inc vat

Out of stockOut of stock
To convert a standard UK spec Single Point Injection car to HIF44 carb. This kit includes wiring looms,fuel tank,fuel pump, carb, air filter and inlet manifold.

($1,424.57) £1.424.57 exc vat

($1,709.48) £1.709.48 inc vat

Out of stockOut of stock

Kit contained products
ACCELERATOR CABLE RHD 1275 CARB MODEL 1990 ON
SBB10099

From 1990 1275 carb cooper fitted with HIF44 and non cooper fitted with HIF38 carb. Also use when fitting metro type carb. This is the right hand drive version except for injection cars.

For LHD use SBB10126 (2.5" shorter)

($10.40) £10.40 exc vat

($12.48) £12.48 inc vat
CHOKE CABLE (36") 1990 on 1275cc
SBF10031

Usually you need to replace the clip ADU5065 when fitting a new cable. This cable is approximately 36" long but a shorter cable was fitted before 1990 until the introduction of the 1275 engine, see SBF10027 which is 32" long...

($10.50) £10.50 exc vat

($12.60) £12.60 inc vat
BOLT FOR BREATHER LLC10047 UNC 5/16"X3/4"LONG
SH505061

The screw that holds the breather on the clutch case housing and is UNC thread 5/16" bolt and 3/4"long--also used on block for petrol pump

($0.27) £0.27 exc vat

($0.32) £0.32 inc vat
CARB SPACER HIF44 (0.56"thick) 14.46mm
GUG705602GM

Spacer with gaskets fitted for any 4 bolt fitting carb such as HS6 HIF range about 9/16" (14.5mm). As this is the only thick spacer you need to check stud length.

($10.00) £10.00 exc vat

($12.00) £12.00 inc vat
SHAKEPROOF WASHER 5/16 UNF
GHF322

Sold individually

($0.18) £0.18 exc vat

($0.22) £0.22 inc vat
BREATHER HOSE FROM BREATHER TO CARB
12A1735

Emission hose from carb to breather valve, this hose has special size ends and made of a material to cope with taking these emission gases.

Approx 23.75" long with internal 5/16" end and 1/2" other end.

GHC406 jubilee c...

($5.65) £5.65 exc vat

($6.78) £6.78 inc vat
NUT PLAIN 5/16" UNF
GFK3212

Zinc plated 5/16" UNF plain nut

($0.09) £0.09 exc vat

($0.11) £0.11 inc vat
STUD FOR THERMOSTAT HOUSING WITHOUT SANDWICH PLATE...
CHS2515

Probably the most changed stud on the mini. This is the length used on every A series engine until the introduction of the sandwich plate when longer ones were required. A stainless steel variety C-STR286 is available which we do recomme...

($0.65) £0.65 exc vat

($0.78) £0.78 inc vat
PLUG 5/8UNF X 5/8 SCREW INLET MANIFOLD
5-8UNF

This plug fits our inlet manifolds and Rover types with servo take off holes..

5/8 UNF grub screw that use 8mm allen key for blanking inlet servo take off or temp transmitter hole at front of pre 1996 cylinder heads. Can also use ADP210

($1.00) £1.00 exc vat

($1.20) £1.20 inc vat
VACUUM PIPE WITH CONNECTORS
37H4229M

Thin plastic pipe with rubber connectors either end. This replaces the old metal type which also had a vacuum chamber built into the line, that was made obsolete. This hose is 26"(660mm)long and has 2 rubber ends, one straight and one at a right angl...

($2.50) £2.50 exc vat

($3.00) £3.00 inc vat
NEEDLE BBW SWINGING - 1300 HIF44 K&N FILTER
CUD1144

If you have fitted our inlet and exhaust manifolds plus an RC40 exhaust to a stadard 1275cc engine this needle in a HIF44 carb will work great if coupled with a K&N pancake filter.

($8.25) £8.25 exc vat

($9.90) £9.90 inc vat
HEATER AND CHOKE CABLE CLIP HIF CARB
CZK6491

Clip on the heater valve for heater cables on vehicles from 1990 where the in line remote heater valve was used. It has also been used as a clip for HIF carbs to hold the cable but the one from Rover is 13H3472.

($1.35) £1.35 exc vat

($1.62) £1.62 inc vat
MANIFOLD GASKET FOR FUEL INJECTED CARS
GUG704053MG

Special reinforced gasket for injection cars has metal inserts on exhaust ports plus a metal back on the manifold side which makes surface easier to clean when replacing. Often used on Turbo cars when correct gasket is in short supply.


...

($5.10) £5.10 exc vat

($6.12) £6.12 inc vat
HIF6/HIF44 PIPERCROSS CONE AIR FILTER KK150
C1504

Pipercross KK150 chrome top, low-conical, foam air filter for 1.75" SU carb.

Full flow, high capacity competition foam air filters; the KK range of Pipercross high performance air filters offer the ultimate in engine filtration, and are...

($36.00) £36.00 exc vat

($43.20) £43.20 inc vat
T PIECE 5/16"
MTP002

Fuel or water T piece adaptor

used when upgrading fuel system size on specials from 1/4" to 5/16" or any other modifications

($4.28) £4.28 exc vat

($5.14) £5.14 inc vat
HIF44 CARBURETTOR
FZX3006

THIS CARB IS A GREAT TUNING AID ON TUNED ENGINES, ESPECIALLY 1380cc.

($624.18) £624.18 exc vat

($749.02) £749.02 inc vat
CARB HIF38/44 ABUTMENT BRACKET
CAM4942

Metal bracket that fits between the manifold and the HIF44 (1.75")carb to hold the cable - the choke cable clip for this bracket is CZK6491. Also for HIF38. For HS4 carb see 12G766 bracket. Original Turbo type [...

($11.93) £11.93 exc vat

($14.32) £14.32 inc vat
FUEL PUMP MECHANICAL. HIF38 cars 1992-4
WND10005

For 1275cc engines after 1990 on with HIF38 carbs.

has a 5/16" (8mm)inlet which makes it unique to this model

The 1990-1 models of the Mini with 1275cc engines and HIF44 carbs use a AZX1817 mechanical fuel pump. Driven ...

($104.15) £104.15 exc vat

($124.98) £124.98 inc vat
DISTRIBUTOR 65D 90-93 HIF44 CARB COOPER
AUU1536

Electronic Ignition distributor, fitted as standard to all 1300 Carb Cooper models. Also Metro 1275cc engine.

Replacement service items for this are:

Cap GDC156

Rotor arm GRA2143

Should be used with GC...

($80.50) £80.50 exc vat

($96.60) £96.60 inc vat
WIRING MAIN LOOM HIF38 CARB CAR-LESS DIM DIP
YMC120890

Main wiring loom less dim dip for mainly overseas cars. Fits all 1275 cars with HIF38 carb from 1991-1994. Ignore alarm wires on early cars.

Main and dash loom only.

($251.76) £251.76 exc vat

($302.11) £302.11 inc vat
BLANKING PLUG FOR LAMBDA SENSOR HOLE
MYB100040

Blanking plug to blank of the Lambda sensor hole on all SPI/MPI models.

($2.63) £2.63 exc vat

($3.16) £3.16 inc vat
REAR LOOM 1992 ON CARB CARS
YMD10745

Rear loom for 1992 on carburettor cars with a 13 way Econoseal plug.

($55.15) £55.15 exc vat

($66.18) £66.18 inc vat
PETROL TANK SALOON 7.5 GALLON 1974 UP TO INJECTION
ARP1043MS

Non Genuine, fits saloons from 1974 until the introduction of injection.

First fitted to 1275GT in 1974 with 12"wheels and all mini saloons from 1980 on

7.5 gallons or 34 litres capacity and the tank is retained by the single stra...

($200.00) £200.00 exc vat

($240.00) £240.00 inc vat