best plug for 12g295 head as fitted to 998 cooper--for tuned head use B7ES.

this is good for any head where a lot has been machined off-flat top pistons.

3 YEAR GUARANTEE-UK made.Large impeller higher capacity water pump with top quality die cast body . Mini Spares procured product as the original superb Rover Airtex tooling has been scrapped.

Fitted with a PPS, glass filled plastic impeller...

Designed to reduce the horsepower drain and slow down the water moving through the radiator to allow it time to cool, its very important for the higher RPMs we run today. This oversize pulley is 4.2" diameter, earlier cars used a 3.875" wide pulley. ...

This thermostat housing fitting kit, suitable for all single tier thermostat housings. Comes with new studs, nuts, washers and Klinger thermostat housing gasket

2 per engine-Longer lasting poly type radiator grommet in Yellow for 1974 on.

These were first used on the one piece cowling from 1974 on. These fit on the lower retaining bolt and 2 are required but sold singly.

Parts required to stop timing chain rattle on A plus engine with single row chain.Last chance to buy the plate and pin to hold the tensioner as they are

obsolete from Rover.

It is worth the expence to fit MSSK051EVOkit...

The last Rover update on the upper engine stabiliser bar, but this is upgraded for performance use.

A one piece silent block type bush, it was fitted at both ends from 1996 on and will fit any cars that had 2 bushes fitted at either end as o...

Copper head gasket for 850-998-1100cc. For tuned engines we recommend GUG702506HG copper head gasket or our composite type for competion or performance engines C-AEA647.

this belt is for use if you have fitted the A plus water pump pulley CAM6408 and using a large dynamo puley C-AEA535

2 plastic 5/8" outlets at the same end and close together which exit the heater on the r/h side. The later HIF38 1275 and single point cars had a change point where the plastic outlets exited on the l/h. This is a JEF10005.

These units take ...