£10.53 exc vat
£12.64 inc vat
£10.53 exc vat
£12.64 inc vat
Recommended usage 1 x 14A6585KIT to fit one mini.
Bootlid seal for Mini <91. Held in place on the boot lid using 26 clips(part# 14A6585).When fitting, the lip part of the seal open end for clips should face the inner boot catch- (the open end of the seal facing inwards to the bootlid al...
Used on all MK1/2/3 bootlids where there are 26 little holes drilled around the inner edge. These are for use with 14A6585 seal--- Later cars 1988 on fitted a seal to the body only (cke10018).
Used on all MK1/2/3 bootlids where there are 26 little holes drilled around the inner edge. These are for use with 14A6585 seal--- Later cars 1988 on fitted a seal to the body only (cke10018).
MkI aluminium boot lid "skin only" panel. This panel is produced off the original tooling, ensuring good panel fit and integrity. Following the pressing of the panel it is hand finished by Heritage craftsmen, to ensure the highest panel quality.
Non genuine double skin MKI boot lid. Always fix your swinging number plate and hinges on for dummy fit and alignment before spraying.
This is the only double skin bootlid avaialble.
The Genuine double skin Mk2 type 8G927...
Non genuine single skin MKI boot lid. Always fix your swinging number plate and hinges on for dummy fit and alignment before spraying.
If you have any doubt about the value of these panels- try having the rust and dents removed fr...
Tank strap bracket welded to the rear of the boot floor which the single diagonal tank strap 21A2838 attaches to.
Key barrel set for Mk3 onwards door handles and boot handles.
This kit contains all the floor brackets and mounts required for fitting Minis with 7.5 gallon tank 10/12" wheels or with 165 profile tyres.
The boot board bracket 14A9783 is not included
For 10" wheels with 145 tyres ...
Taller centre boot board bracket for when wider 165 tyres are fitted to the spare wheel. Supplied with the rubber and pin.
bracket for boot board R/H on 7.7 gallon tank and on both sides for 5.5 gallon tank when 165 tyres fitted
This kit contains all the brackets and mounts required for fitting Minis with 10/12" wheels or with 145 profile tyres.
The boot board bracket 14A9783 is not included
For 10" wheels with 145 tyres and 5.5 gallon tank se...
This very heavy duty bonnet strap is a excellent reproduction of the original factory Special Tuning department special. A copy of our Tan leather strap, but now available in black.
3.3mm thick from the tanneries for use on horse bridles,wit...
Full carpet boot liner kit, completely lines the inside of the boot area.
Not suitable for MPI minis.
Full carpet boot liner kit, completely lines the inside of the boot area.
Not suitable for MPI minis.
Threaded boss that fits in the floor of MK1 minis for the spare wheel clamp 14A6511 to screw into.
Round spare wheel clamp with bolt for fitting in the boot to the spare wheel boss as fitted to Mk1 minis. See 88G479 for the boot floor boss that this clamp screws into.