£35.00 exc vat
£42.00 inc vat
In stock
£35.00 exc vat
£42.00 inc vat
In stockRecommended usage 1 x 14A6739 to fit one mini.
Front A panel part of door frame with door stay hole for internal hinge cars right hand non gen.
Bracket on the end of the dash crossmember (x member holds master cylinders) under bonnet right hand side. The x member is AHC36003
Really a built up half front end for the mini clubman, consists of a lower panel with headlamp panels,slam panel and stiffener between the front and slam panel. 76 ON--no inner or outer wings
The full inner wing with wheel arch section for the mini clubman range --if you need only the first 20" approx of the inner wing see CZH3063.
the left hand waist rail that is supplied on a new bodyside from us.
Acts as a stiffener on the inside of the bodyside between the rear seat pan and the B post just under the rear opening side window
this r/h waist rail is alreday fitted to a new bodyside CZH430 .
It acts as a stifener on the inside of the bodyside just below the rear side window for strengthening between rear seat pan and B post
The left side inner fender of the Mini Clubman should have a metal cowling to focus the air from the radiator to the wheel well. The almost sqaure cowling is spot welded to the inner fender. If you are resoting your car properly you will need to ha...
genuine front panel for the mini clubman before 1976 when the subframe was rubber mounted.see AAM1022 for rubber mounted type as fitted from 1976 on.
the front of these panels is the same but the subframe mounting bracket on the...
The only bonnet landing panel available for the clubman shape body for a long time this part is perfect in every detail and was used on the heritage bodyshells.
A Genuine panel is now available from BL Heritage CZH149.
...
A non genuine panel made for repairing the corner of the windscreen panel which is prone to rust from water splashing up from underneath the front wheel arch.
Experience has shown its easier to fit the genuine panel HMP441001 al...
You can spend hours cutting out rust and patching holes, but why bother? These reproduction floor pans extend the full width with vertical flanges for easy installation and fairly well represent the original stamping. They have added metal to include...
Only this genuine wing is now available for the mini clubman but you will probably require the headlamp backing panel CZH120
Only this genuine wing is now available for the mini clubman but you will probably require the headlamp backing panel CZH121
You can spend hours cutting out rust and patching holes, but why bother? These reproduction floor pans extend the full width with vertical flanges for easy installation, and fairly well represent the original stamping. They have added metal to includ...
THIS PANEL PROTECTS THE UNDERSIDE OF THE WINDSCREEN VALANCE UNDER THE FRONT WING SECTION also fitted on the inner wing panel 14A8346/7
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.