Front progressive bump stop kit for hydrolastic cars. Mounting brackets and rubbers. Improves car handling; especially under braking and when fully loaded.

Rubbers are available separately, AHH7074.

See C-AJJ33...

Same bump stop as fitted to MGB, this was utilised by ST Works Abingdon to go on their bump stop kits C-AJJ3313/4007 for hydrolastic minis. Sold singly.

Genuine Mini Spares standard performance cone utilizing 20 years of elastomer/rubber technology from our competition cones manufacturer. Only beeen available since 02/09/2020 and proudly made in the UK with 10,000 sold by 2023.

Original cone...

New Evolution design in 4mm thick metal mase to fit Genuine and our non genuine subframes better than the standard originals.

The amount a wheel leans in or out at the top is called "camber". As the car turns and the body leans the tire can ...

Plastic plug suplied in rear strut kit for HILO's.

All models of the Mini use the same rear hub (this piece holds the rear wheel bearings). The Mini's rear wheel bearings are more than adequate, usually requiring only occasional repacking with grease. The weak link may be the cast iron hub; it is not...

Genuine Mini Spares product ideal for road use for maximum performance, where other examples available tail off as they get worked and heat up.

Hilos will be required to enable fitment as they are taller but FAM3968EVO are a str...

Exchange arms for dry suspension, later type with a bush and bearing.

We will not accept very early 2 bronze bush type from the 1959/60 era or any arms if they are bent or damaged. If you've ever had to rebuild a Mini trailing arm you know w...

Exchange arms for dry suspension, later type with a bush and bearing.

We will not accept very early 2 bronze bush type 1959/60 era or bent damaged arms.

If you've ever had to rebuild a Mini trailing arm you know what a hassle it can...

Each Hi-Lo Suspension Kit Includes one pair of Hi-Lo trumpets and nylon knuckle cups which will fit front or rear, but you will need the sleeved rods HILO-01 to enable fitment to the rears. For a car set you require 2 HILO k...

Mini Spares product from own original tooling since 1989.This small sheet metal panel mounts below the horizontal seam, covering the pivot pin of the R/H rear radius/trailing arm.

This shroud uses 14A7091 rubber plug not suppl...

Floor pan front to rear for the left hand side, only to the floor shape before rod change cars - ideal for MK1/2 restoration.