PERFORMANCE STAGE 1 KIT HS4/HIF38 1275 BIG BORE CE...

Performance Stage one kit for 1300cc models with HS4 or HIF38 Carb with centre exit large bore exhaust system.

Always get your car rolling roaad tested for best ignition/timing and emmissions after fitment.

£289.89 exc vat

£347.87 inc vat

PERFORMANCE STAGE 1 KIT HS4/HIF38 1275 LARGE BORE ...

C-STN18C

Performance Stage one kit for 1300cc models with HS4 or HIF38 Carb with side exit large bore exhaust system RC40-010

Always get your car rolling roaad tested for best ignition/timing and emmissions after fitment.

£289.05 exc vat

£346.86 inc vat

K&N HS4/HIF AIR FILTER ELEMENT

E2601

The stock air cleaner housing for many Minis with single 1 1/2" SU carbs have historically been stuck with the paper filter. New from K&N is a replacement element for FZX3013 and all HIF that provides the benefits of K&N cleanable filtra...

£43.05 exc vat

£51.66 inc vat

RC40 EXHAUST FITTING KIT

RC40FK

Complete mounting kit for the RC40 exhaust. Includes all new rubber mounts, brackets and clamps.

£6.85 exc vat

£8.22 inc vat

GASKET 1.5" CARB TO MANIFOLD

AEC2083

Gasket for an HS4-carb and manifold .Sold seperately and order as required for your car(usually 3).

£0.56 exc vat

£0.67 inc vat

MANIFOLD GASKET INLET / EXHAUST

AJM601

Manifold gasket fitted to all A series pre 1992 except Turbo which had a reinforced exhaust ports GUG704063MG and SPI from 199. From 1991 on a new better gasket with reinforced exhaust ports and backing was fitted GUG704053MG

£0.96 exc vat

£1.15 inc vat

PLUG 5/8UNF X 5/8 SCREW INLET MANIFOLD

5-8UNF

This plug fits our inlet manifolds and Rover types with servo take off holes..

5/8 UNF grub screw that use 8mm allen key for blanking inlet servo take off or temp transmitter hole at front of pre 1996 cylinder heads. Can also use ADP210

£1.00 exc vat

£1.20 inc vat

MANIFLOW COOPER FREEFLOW EXHAUST MANIFOLD

C-STR816

Maniflow's tubular reproduction of the original Cooper 997/998cc exhaust manifold manufactured out of the same tubing as the STD bore LCB. This free flow manifold works vey well at lower speed pick up, the LCB is noisier but better at the top end of ...

£87.45 exc vat

£104.94 inc vat

DOWN PIPE RC40 TWINBOX TO FREEFLOW C-STR816 MANIFO...

RC40-001

Original RC40 downpipe. This pipe is the correct length to fit the rear twin box RC40 system to the original Cooper and "S" range of manifolds or the replacement C-STR816 Freeflow manifold. If fitting to an LCB ...

£8.88 exc vat

£10.66 inc vat

NEEDLE AAM SWINGING - STAGE ONE 1275cc 1.5" CARB

CUD1011

£8.25 exc vat

£9.90 inc vat

TWIN BOX RC40 EXHAUST

RC40

Mini Spares genuine RC40 system has justifiably earned the reputation of the best exhaust ever made for the Mini. Mild steel with stainless steel tailpipe. Typically used with an LCB manifold it gives great performance with a mellow soun...

£60.50 exc vat

£72.60 inc vat

PERFORMANCE STAGE ONE KIT 998

C-STN17

STAGE 1 KIT. Mini Spares bolt-on performance kit for 998 and 1098 engines with HS4 carb. Gives 20% more power and 12% more torque.

Using all the top quality tried and tested parts the Kit includes

RC40 twin box [link]RC...

£243.08 exc vat

£291.70 inc vat

RC40 REAR TWIN BOX SYSTEM FROM CATALYST BACK

C-STR812

Rear RC-40 twin box system to fit catalyst for cars built late 1991 on SPI(not early carb coopers). It has the hanger rods fited for mounting onto the rubber type straps. This makes it a twin box system with a little throatier pleasing note, but a mu...

£67.34 exc vat

£80.81 inc vat

RC40 SHORT DOWN PIPE FOR TWINBOX TO LCB MANIFOLD

RC40-002

LCB pipe for RC40 twin box.

This pipe is the correct length when using our range of standard bore LCB

such as C-AEG364 & C-AEG365.

1.750"OD

£9.98 exc vat

£11.98 inc vat

MANIFLOW VAN AND PICKUP TWIN BOX EXHAUST SYSTEM

C-ARA339

The long wheel base of the Mini Van, Wagon and Pick-up means the popular RC-40 exhaust comes up a little short! This system from Maniflow (pipes, resonator and muffler), is made for the long bodies. It has the same great flow characteristics of the ...

£146.28 exc vat

£175.54 inc vat

MANIFOLD GASKET FOR FUEL INJECTED CARS

GUG704053MG

Special reinforced gasket for injection cars has metal inserts on exhaust ports plus a metal back on the manifold side which makes surface easier to clean when replacing. Often used on Turbo cars when correct gasket is in short supply.

...

£5.10 exc vat

£6.12 inc vat

BLANKING PLUG INLET MANIFOLD & CYL HEAD

ADP210

This 5/8unf steel hexagonal head blanking plug was made for the inlet manifolds where the servo union can be fitted, plus blanking off the thermal transmitter hole under the thermostat. Uses 1B3664 washer ----------please note this will ...

£3.57 exc vat

£4.28 inc vat

DOWN PIPE RC40 TWINBOX TO FREEFLOW C-STR816 MANIFO...

RC40-001

Original RC40 downpipe. This pipe is the correct length to fit the rear twin box RC40 system to the original Cooper and "S" range of manifolds or the replacement C-STR816 Freeflow manifold. If fitting to an LCB ...

£8.88 exc vat

£10.66 inc vat

INJECTION LCB MANIFOLD WHEN DELETING CAT

C-AEG374

LONG CENTRE BRANCH EXHAUST MANIFOLD FOR FUEL INJECTED CARS WITH A SENSOR TAKE OFF in main LCB body, THIS IS FOR USE WHEN THE CATALYST IS BEING REMOVED AND A RC40 EXHAUST IS BEING FITTED. If the catalyst is to be retained use [link]C-AEG3...

£99.91 exc vat

£119.89 inc vat

REAR COTTON REEL EXHAUST MOUNT

GEX7251

The very rear bobbin type mounting rubber on every mini made until the introduction of a rubber hanger strap in 1992. When the RC40 or similar systems are fitted, 2 will be required.

See C-19G3258 for larger upgrade...

£1.05 exc vat

£1.26 inc vat

WASHER FOR MANIFOLD THICK TYPE

12A1211

The intake/exhaust manifold should be secured to the head with brass nuts and these very thick washers. These washers are intended to not only spread the clamping action but the thickness allows them to absorb the heat without deforming! Takes 4 per ...

£0.34 exc vat

£0.41 inc vat

MANIFLOW CENTRE EXIT TWINBOX 1.75" BORE EXHAUST SY...

C-ARA332

1.75" bore twin box, centre exit exhaust system. This exhaust system by Maniflow is straighter and louder than the RC-40. Very high quality with a skid plate on the bottom of the muffler and a polished stainless tip.

£119.36 exc vat

£143.23 inc vat

MANIFOLD LOCATING RING

12G297

Locating rings originally made for 12G295 heads with twin carbs to line up the inlet manifold to the inlet ports on the cylinder head it found its way on most twin carb factory produced cars. There is a recess in the inlet port on the he...

£2.56 exc vat

£3.07 inc vat

MANIFOLD GASKET INLET / EXHAUST

AJM601

Manifold gasket fitted to all A series pre 1992 except Turbo which had a reinforced exhaust ports GUG704063MG and SPI from 199. From 1991 on a new better gasket with reinforced exhaust ports and backing was fitted GUG704053MG

£0.96 exc vat

£1.15 inc vat

EXHAUST U BOLT CLAMP 2" 50mm

GEX9006

£0.74 exc vat

£0.89 inc vat

DOWNPIPE TO GEARBOX EXHAUST BRACKET

GEX7526

This bracket bolts on the gearbox and attaches to the exhaust front downpipe clip GEX7053.

£11.00 exc vat

£13.20 inc vat

RC40 EXHAUST DOWNPIPE FREEFLOW MANIFOLD TO REAR BO...

AN180V

Copy of the original Cooper single rear box downpipe, this fits our freeflow manifold or can be shortened to fit an LCB when fitting the single rear box C-STR809 RC40 silencer.

A 3" longer version suitable for van/e...

£13.54 exc vat

£16.25 inc vat

RC40 EXHAUST FITTING KIT

RC40FK

Complete mounting kit for the RC40 exhaust. Includes all new rubber mounts, brackets and clamps.

£6.85 exc vat

£8.22 inc vat

RC40 CLASSIC REAR BOX ONLY

C-STR809

Rear RC40 mild steel silencer with stainless steel tailpipe. Can be used as a single box system with down pipe number AN180V for a little throatier note.

Cars with catalyst use with AN181T for 1275 Coo...

£35.46 exc vat

£42.55 inc vat

LINK PIPE TO REPLACE CATALYTIC CONVERTER

C-ARA664

If you wish to delete the catalyst (legal restrictions apply, so check to see if you are allowed) this pipe is specially made to replace it.

£32.99 exc vat

£39.59 inc vat

GASKET FOR EXHAUST CATALYTIC CONVERTER

GEX7761

Metal gasket for the catalyst and is the same both ends for Cooper 1275CC RSP early cars, but only fitted on the front to later cars. If you cannot fit this gasket on the rear your car does not need one.

£0.67 exc vat

£0.80 inc vat