£40.16 exc vat
£48.19 inc vat
In stock
Achievable drop gear ratios when using our Evolution gears:
22 tooth primary - 30 tooth idler - 25 ...
£40.16 exc vat
£48.19 inc vat
In stockRecommended usage 1 x C-STR250 to fit one mini.
Nut to hold the broach (input) drop gear on the 1st motion shaft and don't forget the DAM4000 locktab. Tiny cut-outs / chamfers go towards the gear as not to dig into the lockwasher as the nut is done up.
Idler gear conversion for straight cut drop gearsets only.
This set up is for A plus idler gearbox cases only and uses a single roller bearing centrally unlike the old timken conversion which had taper bearings either end.These gears are ba...
Straight cut drop gears are the most durable arrangment that can be fitted to a transverse A-series powerunit. These 3 gears are responsible for transferring all the Hp from the motor to the gearbox, so their longevity should be a top priority for an...
Straight cut teeth broach gear for the 1st motion shaft which runs with the straight cut idler and primary gear combinations. This has 23 teeth and one identification ring on actual teeth.
Achievable drop gear ratios ...
Evolution Straight cut 24 tooth 1275 primary gear.
Evolution Straight cut 23 tooth 1275 primary gear.
Ongoing development and investment of bringing parts up to date from yesturyear with current technology Mini Spares h...
Evolution Straight cut 22 tooth 1275 primary gear.
Evolution Straight cut 23 tooth 1275 primary gear.
Ongoing development and investment of bringing parts up to date from yesturyear with current technology ...
Evolution Straight cut 23 tooth 1275 primary gear.
Ongoing development and investment of bringing parts up to date from yesturyear with current technology Mini Spares have introduced new EVO straight cut drop gears. With new 2 r...
24 tooth primary gear bush for small bore applications, with floating bush
S/C 30 tooth idler gear for A+ boxes using the 7/8" shaft.
Achievable drop gear ratios when using our Evolution gears:
22 tooth primary - 30 tooth idler - 25 tooth input = 1.136-1
24...
Minispares were the first company to produce these layshafts for performance engine/gearboxes as the standard type would flex and resullt in the breakage of the bearings causing seizure. Produced in an upgraded material and heat treated to the correc...
STRAIGHT CUT FIRST MOTION GEAR FOR PRE A+ GEARSET £95.25 exc vat £114.30 inc vat
19 teeth
See table of "Straight Cut Gear Kits" and their components
Straight cut reverse gear for rod change box. Has 16 and 18 teeth. £73.47 exc vat £88.16 inc vat
See table of "Straight Cut Gear Kits" and their components
