Performance Stage one kit for 1300cc models with HS4 or HIF38 Carb with side exit large bore exhaust system RC40-010

Always get your car rolling roaad tested for best ignition/timing and emmissions after fitment.

This sleeve will allow an 1"3/4 rear box to fit a standard bore front pipe of a 998cc mini. The large end fits into the RC40 and the smaller end accepts the 1.25" diameter as standard 850/998 exhaust pipe bore

Exhaust manifold to downpipe clamp for turbo

Exhaust centre strap that hangs from the mounting on the centre of the rear subframe, for saloon models only as the van is longer(GEX7273).

The clip on the exhaust that this attaches to is GEX7052 and is usually on a new exhaust...

This is a bolt on conversion bracket to fit on the rear of the rear subframe to take the later type rubber strap mounted exhaust systems.Later subframes 1991 on had these parts welded in position.

Exhaust manifold to downpipe clamp.

The key to eliminating exhaust leaks at the manifold flange is the clamp. These new clamps include proper brass nuts and support washers. Fits most 850cc, 948cc, 998 etc. Those engines with single carb an...

The center exhaust hanger takes a lot of abuse during hard acceleration or if you're low enough to bottom out on bumps. This mount has a through metal bolt to keep it intact.

The very rear bobbin type mounting rubber on every mini made until the introduction of a rubber hanger strap in 1992. When the RC40 or similar systems are fitted, 2 will be required.

See C-19G3258 for larger upgrade...

This is the hanger on the rear of the rear subframe for all Coopers and cars with an RC40 exhaust system. The u bolt to fix this to the exhaust is GEX9007.

All the parts to hang RC40 exhausts systems are available i...

This is the clamp for the C-AEG365 manifold that clamps it to the engine for extra support.

Larger, stronger rear exhaust mounting as used by works cars will usually fit earlier subframes on existing holes in either the middle or side exit position.