£17.60 exc vat
£21.12 inc vat
In stock
Best internal parts tested and another intermotor top product.
Its not the name on the outside but whats on the inside which matters.
Original type coil bracket 12G2994 with welded on lug nuts is available as fitted from 1969-1995
£17.60 exc vat
£21.12 inc vat
In stockRecommended usage 1 x MSC110 to fit one mini.
Introduced by the factory to erradicate water getting to the electric coils causing breakdowns this was used up until they introduced the plastic engine protection shield but many owners still played safe and fitted one anyway.
Made in plast...
This sleeve fits most Lucas and Unipart coils to give the impression thay are stainless steel. Comes with a s/steel bracket. Covers just over 4.25"(11cm)long
Coil bracket fitted to end stud of cylinder head,clutch end for coil to mount on as fitted 1969-94-MK3 on. This has been made to the original specification with the welded lug nuts rather than the cheaper method of having just plain holes to take a b...
Ultimate coil from lumenition has spiral bound wire giving instant and greater
resonance. Not Suitable for injection Mini's.
For sports coil for use on resistor type cars 1982 to 1992 with 998cc engine from factory, MSC110<...
Ballast type coil fitted from Aug 1982 up until 1989 998cc cars,
1.6ohms
GCL144 was original equipment and GCL217 was the aftermarket replacement. Our research,sales and feed back shows Intermotor coils to be the best a...
Wiper motor fitting kit to fit all mk2 onwards wiper motors to the bulkhead.
Battery bar and fitting kit for all pre 1990 cars whcih had the shorter battery bolts.
This will replace the orange lens fitted on the wing of all cars from 1986 on, fitted with an orange LED. If you need a new loom for this lamp see AFU3358. Sold singly. Does not require a resistor.
Genuine Bosch lambda sensor, fitted to both the twin and single point injection cars and fitted in the same exhaust manifold shared by both cars. Be warned the cheaper non branded sensors cause lots of issues hence we only sell the Bosch version.
Electronic ignition conversion. For points type distributors, fixed or sliding. Negative earth only. Also, available for earlier 23/25D on Negative earth (LU142) or earlier 23/25D with Positive earth (LU142AP12).
ONLY use GCL217 coil for bal...
Pre A plus Electronic Ignition distributor, with vac unit modified to give better performance on any minis with 285/286/296 camshaft profiles
Brand New distributor complete with electronic conversion already fitted.
PRE A PLUS
<...
Pre A Plus Electronic Ignition distributor with vac unit, modified to our specification in the UK to give best performance on any minis with std to 276 camshaft profile.
Brand New distributor complete with electronic conversion already fitt...
This is the hazard switch repair plug for post 1976 rocker switches, pins supplied so you can wire accordingly.
Lots of things have been written about performance plug ignition wires but regardless of what you believe we all know that good wires are a must. This special competiton wires set from the Lucas factory has 8mm wire and the highest performance, no br...
Small battery cable retaining bracket bolted at the front of the engine for pre engaged manual cars approx 1985 onwards.
Wiper Swithch MK1/2/EARLY MK3 blade type switch for using to convert to 2 speed wipers when current 2 speed wiper motor is used.
For those very early 25D type distributors.Mini Spares version for modern fuels as fitted to our distributor range with slide on vaccum hose inlet pipe-not the very first screw in type
For modern day petrol, except 1275cc. See 37H8379MS for 1275cc.
After lengthy tests we have found nearly all vac units are not to the originals but with the change of added oxygenates to petrol in the 1980's and then ethanol in ...
best plug for 12g295 head as fitted to 998 cooper--for tuned head use B7ES.
this is good for any head where a lot has been machined off-flat top pistons.
Lightweight higher power version of GXE1004 (1.6KW as apposed to 1KW), ideal for race/tuned cars with high compression and cars that need more room for oil coolers etc. See GXE1005RACE for pre engaged.
Rear wiring loom for SPI cars. These have bullet connectors to join the front loom, later cars had a multiplug which use YMD10717.
Negative earth only-45D electronic distributor with vac for 1275GT and any pre A Plus 1300cc engine including Sprite and Midget in line engines-
For best performance and tune we advise our electronic Evolution version C-27H7698<...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.