£45.77 exc vat
£54.92 inc vat
Out of stock
£45.77 exc vat
£54.92 inc vat
Out of stock
Cooper cars with HIF44 carb from 1990-91 R/H/D with pre engaged starter,side repeater lamps on wings, 3 clock instruments--The Cooper LE(RSP) 1990 model has different loom listed as YMC11388 but this loom has been used by trade customers...
Rear body harness with speaker wires, known as thick wall type which was replaced by thin wall PVC covered wire type in 1989. AN169 is the thin wall equivalent and occassionly fitted or found on early cars wothout any problems.
...
You should always use this kit for fitting any auxiliary spot or fog lamps.
Kit contains wiring and safety relay-cheaper than a burnt out engine compartment.
Please note, SPI and MPI cars have this facility built as standard safety ...
The battery cover made of a special cardboard as fitted to all minis to protect
the battery terminals from metal objects. See also the 14A7666 retaining strap.
1976 facelift type on in PVC for 1275GT only
Instrument pack wires require use of your old wiring block.
A plastic lamp spade connection with sidelight bulb aperture for use on sealed beam units only. Uses a GLB501 capless bulb. The mini clubman used sealed beams but had independant side lamps and therefore had an equivalent unit less the s...
Cars with pre engaged starter,side repeater lamps on wings, dim dip unit pre Ocober 1988 production cars without servo and brake combined cylinders. R/H/D.
Original HAM4626 has pinkish brown resistance wire for ballast type coil...
Electronic Distributor for any standard A+ 998cc. Negative earth only.
From 1982on 998cc were fitted with a ballast coil which means a new wire must be fitted from fusebox top left terminal where there is a large white cable to the...
Plastic holder for the later flasher unit GFU2218. Needs to be mounted to the bulkhead prior to fitting the flasher unit to the holder
This is the plug that fits on the back of the front indicator lamps (XBD100670) on mpi models.
Single bullet connector used to join the front loom to the rear loom near the wiper motor.
Double bullet connector used to join the front loom to the rear loom enar the wiper motor.
Foam gasket that goes between the indicator/side lamp unit and front panel for all clubman models
1.0 KW steel gear reduced unit, that draws less current from the battery when starting. Huge increase in comparison to the original units, and are a direct replacement part for the original pre-engaged starter motor.
Not ...
Printed circuit board for 1989 to 1996 3 clock Nippon Seiko type Mini gauge clusters. These have been unavailable for many years but have now been remade exclusively for Minispares.
THE LENS FIXING SCREWS FOR THE REAR LENS ON MK4 1976 ON WITH REVERSE LENS ARE ALL THE SAME. SOLD INDIVIDUALLY. ALSO FITS TWIN POINT FRONT INDICATOR LAMP.
3 per lamp required or 6 per car set.
Pair of high power Chrome Fog lights. 5.5"( 135mm )diameter, 50mm deep with durable plastic covers. Universal fitting. The lamp is nearly all forward of the mounting bracket making it great for fitting in front of mini grilles. Bulbs are H3 type 55 w...
Printed circuit board for pre 1989 cars with Smith's type 3 clock gauge clusters. These have been unavailable for many years but have now been remade exclusively for Minispares.
Front side and indicator R/H lamp for the Mini Clubman range plus Lotus and Maxi. These come with body seal and lens seal complete.
These are copies as the original base tooling by Lucas was scrapped.
Seperate parts if required are ...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.