Electric water gauge as standard on the centre binnacle Mini. Marked "C-N-H" Genuine Smiths. For post 1964 vehicles with voltage stabiliser fitted on speedo.

The early type had 3 connector tabs on one long brass strip for wires where as thi...

This unit fits directly on to the gearbox in place of the standard cable and produces a digital signal for use with any electronic speedometer requiring 12 or 5 volt square wave pulse such as our electronic speedo 13H4443. Fits post 1980...

Complete binnacle set for centre speedo cars, kit includes 130 mph electronic black speedo, temperature gauge, oil pressure gauge, binnacle and chrome surround (incl clips). Mini Spares also have a short loom which converts 3 clock Nippon

Se...

This unit fits directly on to the gearbox in place of the standard cable and produces a digital signal for use with an electronic speedometer requiring a 5 volt square wave pulse such as our electronic speedo 13H4443. For pre 1980 speedo...

The black plastic pod which mounts the speedo and two gauges in the original central position. In the 1970's and 1980's a great number of Mini owners caught the customizing bug and a lot of Minis had custom dashboards installed. Now we're going the o...

Speedometer illumination lamps

These tiny light sockets snap into the back of the speedometer to light the way. If they won't stay in place check yours for spring tension or missing tangs.

Originally took screw in bulb [link]GLB987...

This is the bulb holder for the original Smiths auxillary gauges fitted to 3 clock centre dashboards i.e 13H4459 and 13H4460, will also fit the aftermarket Smiths gauges (SIB part numbers).

Smaller 52mm face and reading 0-80 x100---If you are serious about your driving then you want to understand how your engine is responding to your urges. Many types of tachs are available in the aftermarket but since we drive British it should say "S...

This is a dummy control box (GEU6603) for use with the Dynalite alternators, enabling you to keep your engine bay/wiring looking original even when you are using an alternator. All wire can be swapped like for like from your old regulator box except ...

Single bullet connector used to join the front loom to the rear loom near the wiper motor.

1.0 KW steel gear reduced unit, that draws less current from the battery when starting. Huge increase in comparison to the original units, and are a direct REPLACEMENT FOR ORIGINAL 9 TOOTH INERTIA STARTER MOTOR.ONLY FOR 107 TOOTH RING GEARS. WILL...

Sold individually, these are R/H/D.

RHD HEADLAMPS DIP TO THE LEFT.



Brand new Free Form light unit from Wipac with clear Polycarbonate lens but the backing bowl is specially designed to reflect the beam and give better pen...

With this large diameter line to the oil pressure guage you can actually see minor fluctuations in the pressure at idle or when the relief valve bounces open and closed. Because the braided steel line is one piece from the block to the gauge there is...