WING TO A PANEL SUPPORT
14A7602

(¥2) £2.30 exc vat

(¥3) £2.76 inc vat

In stockIn stock
Small angled bracket fitted by factory to stiffen front wings to A panels

(¥2) £2.30 exc vat

(¥3) £2.76 inc vat

In stockIn stock

Recommended usage 1 x 14A7602 to fit one mini.
Saloon and Front Ends - Qty 1

People also bought products

BARE BULKHEAD SKIN



THIS IS THE LATER MPI PRESSING, BUT CAN BE CONVERTED TO SUIT EARLY CARS BY EITHER CUTTING ROTADIP HOLE YOURSELF, OR BY FITTING THE PRE FORMED HMP441017



A VERY CHEAP PANEL THAT CAN BE CUT TO MAK...

Crossmember to inner wing bracket bracket for Mk1/2 L/H

not mini clubman

Crossmember to inner wing bracket bracket for Mk1/2 R/H

not mini clubman

Rear subframe mounting stiffener L/H repair bracket with holes for subframe mounting and attaches to wheel arch Fits on ALA8623

Rear subframe mounting stiffener panel R/H with holes for subframe mounting to wheel arch. Sits on ALA5524 or ALA5528

Rear handbrake bracket. 1976 onwards for single cable lever. Welds to tunnel. Not included on CZH2669 floor. For forward bracket see CZH3214.

This is small plate that welds into the later lower dash rails to convert them to mk1 size for people who want early switches in a late car.

MkI aluminium boot lid "skin only" panel. This panel is produced off the original tooling, ensuring good panel fit and integrity. Following the pressing of the panel it is hand finished by Heritage craftsmen, to ensure the highest panel quality.

Metal floor plug as per original with rubber seal.



For use in 1" hole.

Although this panel is non genuine it is the most accurate for MK1 Cooper S restorations as it has the correct number plate brackets and slam panel.

If you have a pre 1964 car with the one piece valance with no cooling cut outs for brakes ...

Non genuine rear companion bin for external hinge cars. These are supplied without the ash try mount.

Non genuine rear companion bin for external hinge cars. These are supplied without the ash try mount.

The last type of rod change rib design floor made for the assembly line fits cars from 1997-2000. It has a large rib down the centre of the L/H side.

This floor produced from genuine tools has the crossmember fitted with the sill panels an...

Body side rear lower w/arch to rear section of bodyside repair L/H. 220mm tall.

Repair section of bottom of door for external hinge cars, MK1/2.

This crude non genuine parts is the only repair section available for early doors apart from door skins.Lots of stretch marks and wrinkles but they have been fitted by customer...

Repair section of bottom of R/H door for external hinge cars, MK1/2.

this crude non genuine parts is the only repair section available for early doors apart from door skins. Lots of stretch marks and wrinkles but they have been fitted by cus...

non genuine L/H outer MK3 door skin lower few inches repair section.

not as good a fit or looking as the genuine complete skinCZH3301

non genuine R/H outer MK3 door skin lower few inches repair section.

not as good a fit or looking as the genuine complete skin CZH3301

Non genuine L/H saloon inner sill. Only made as an after market replacement as no genuine part was ever available seperately. Best one on the market for a comlplete inner sill replacement panel. With carpet fix brackets.