Every mini saloon has these,2 of 24A41 on either side front and 24A42 /24A43 sided on the rear --only purpose was for building/moving/ storing and preparation of cars at the factory to sit them on . Also acted as a stiffener...

Rear handbrake bracket. 1976 onwards for single cable lever. Welds to tunnel. Not included on CZH2669 floor. For forward bracket see CZH3214.

Aftermarket version of the rear R/H floorpan for 1992 on cars.

Appears to be a part section of the genuine whole length floor Right hand side.

This has extra length to go just under x memeber at 37.5"95cm long and under glove compar...

wiring tag 55mm long and 70mm overall.

You can spend hours cutting out rust and patching holes, but why bother? These reproduction floor pans extend the full width with vertical flanges for easy installation and fairly well represent the original stamping. They have added metal to include...

The crossmember holds the seat brackets and has the correct shape on the bottom to sit correctly on the floor of the rod change tunnel only. This is the complete section from inner sill one side to the other. Fits all square type rod change gearbox f...

Every mini saloon has these,2 of 24A41 on either side front and 24A42 /24A43 sided on the rear --only purpose was for building/moving/ storing and preparation of cars at the factory to sit them on . Also acted as a stiffener...

outer sill panel for van and estate versions L/H from genuine tooling but we consider it a MK3 floor shape pressing

Every mini saloon has these,2 of 24A41 on either side front and 24A42 /24A43 sided on the rear --only purpose was for building/moving/ storing and preparation of cars at the factory to sit them on ..Also acted as a stiffener...

THIS IS THE REINFORCER STRIP THAT WELDS TO THE FRONT EDGE OF THE SEAT BASE TO STOP IT BENDING

Crossmember to inner wing bracket bracket for Mk1/2 R/H

not mini clubman