Amal carburettor kit for the Arden 8-Port head. Complete with carbs, manifolds and linkage.

A pair of fabricated steel inlets for 8 port cylinder heads

this were made to take twin webers and fit under the bonnet but might require small amounts of modifications on some vehicles. 60mm long

Not tremendously efficient due to t...

Aftermarket union for fitting all mini inlet manifolds where a take off is required for your brake servo or emission valve on Cooper S cars.

The newest development in the A-series engine is the use of these nuts with swedged-on washers. The washer will not separate from the nut, so you won't lose it. Yet the nut rotates independently while you tighten it. What a great idea.

Complete with screw the choke trunnion is used on nearly all SU carb linkages.

See ACC5062 for carb cable link trunnion also.

Pin to hold the accelerator cable which locates in the carb bracket lever. Supplied as originally fitted with washers, nut and split pin plus a proper machined hole for the cable unlike many others on the market- which come either bare or with wrong ...

Gasket for an HS4-carb and manifold .Sold seperately and order as required for your car(usually 3).

These Swedish made Misab plates are known as the best for mounting your 40/45DCOE carb to its manifold to avoid fuelling problems. Sold singly per gasket

This fitting kit suits all later day 1.25" and 1.5" twin carb set ups where the balance rods between the carbs required are equal length (2.25"), some early carbs had the balance bar with a triangular plate that were a shorter length. The kit has the...