(¥9) £9.00 exc vat
(¥11) £10.80 inc vat
In stock
(¥9) £9.00 exc vat
(¥11) £10.80 inc vat
In stockRecommended usage 1 x HPS8 to fit one mini.
Mini Copper Sump Drain Plug Washer, also will fit the oil transfer pipe block fitting on Pre 1992 Blocks.
Combined water temprature and oil pressure gauge.
Water temprature includes calipllary tube and adaptor to fit into the cylinder head, oil pressure gauge doesn't include the capillary fittings. Not for MPI minis.
Combined water temperature and oil pressure gauge.
Water temprature includes calipllary tube and adaptor to fit into the cylinder head, oil pressure gauge doesn't include the capillary fittings. Not for MPI minis.
40-150 centigrade original oil temp gauge from the Stuart warner range of competition accurate clocks with black face--great clocks but we are deleting line and only have a few left--retail was over £50-00 and we paid £34-00 6 years ago
With this large diameter line to the oil pressure guage you can actually see minor fluctuations in the pressure at idle or when the relief valve bounces open and closed. Because the braided steel line is one piece from the block to the gauge there is...
Angled oil pipe adaptor for fitting in confined spaces to eradicate damage of oil pipe, requires an OA adaptor if being used with a oil pressure gauge/t-piece.
Oil pipe in plastic 5 feet long, if fitting to a Tim gauge you will require LMA017 adaptor for the gauge.
Not comppatable with the CAM6431 standard oli pressure block union, and OA shoudl be purchased to fit.
Oil gauge adaptor for fitting into engine block or T piece.
29" long for L/H/D cars from about 1988 on when Seiko nippon speedo gauges are fitted. earlier cars used a 33" cable GSD102 which had the grey end but are interchangable and cheaper.
A must if you want to run a mechanical oil gauge and retain the oil warning switch. Screws straight into the block on all A series engines.
Speedometer cable, 30" long for Smiths type central speedo-original was 26" long
Mini Moke Speedo Cable for the Centre clock type speedo,also 13" longer to allow the Smiths type central speedo to be moved.
If you have an early Mini saloon or Estate/Van or Pickup with the fuel tank sending unit held in by screws, this is the correct screw for you.
Do not forget the special copper washers also 2A2088 and the cork gasket [link]2H10...
You will need this union for your Tim gauge if you fit a replacement plastic oil pipe part number OL
Extra long cable for Smiths central located speedo when position moved in dash and also used as a Tacho cable for Sprite, 36" long.
48" extra long speedo cable for special fitmentswhen using original type Smiths central mounted speedo.
Electric water gauge as standard on the centre binnacle Mini. Marked "C-N-H" Genuine Smiths. With a magnolia face.
Does not come with bulb holder or bulb.
Electric water gauge as standard on the centre binnacle Mini. Marked "C-N-H" Genuine Smiths. For post 1964 vehicles with voltage stabiliser fitted on speedo.
The early type had 3 connector tabs on one long brass strip for wires where as thi...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.