(¥29) £29.27 exc vat
(¥35) £35.12 inc vat
In stock
these are made similar to the original cooper HS2 design but ARE for HS4 (1.5")carbs and include the 3 correct springs that attach to the bridging bar for choke return linkage
(¥29) £29.27 exc vat
(¥35) £35.12 inc vat
In stockRecommended usage 1 x MSSK1004 to fit one mini.
Stainless steel twin HS4 heatshields kit. Comes with Link bar and springs.
Not Built up= A Complete kit of HS4 CARBS/ MANIFOLD/LINKAGE LESS AIR CLEANER
Throttle return springs for all twin carb variants. Usually 3 fitted.
Twin carb HS2 (1.25")black heatshields with link bar and 3 new return springs.
Before the days of Aeroquip, Minis were fitted with braided steel rubber fuel lines. They should be used in place of rubber for all fuel lines in the engine compartment. They come made to length, with rubber end caps. 1/4" bore size.
Orange ...
Clip on the heater valve for heater cables on vehicles from 1990 where the in line remote heater valve was used. It has also been used as a clip for HIF carbs to hold the cable but the one from Rover is 13H3472.
Before the days of Aeroquip, Minis were fitted with braided steel rubber fuel lines. They should be used in place of rubber for all fuel lines in the engine compartment. They come made to length, with rubber end caps. 1/4" bore size.
Orang...
Stainless steel twin HS4 heatshields kit. Comes with Link bar and springs.
Throttle return springs for all twin carb variants. Usually 3 fitted.
This is the right hand linkage lever taht sits on the rods between HS type twin carbs. Sold individually
Manifold to carb gasket for HS2 single and twin carbs, usually 3 per carb required.
Used in petrol fuel lines to take 1/4" petrol hoses it is used mainly on twin carb set ups for petrol being diverted to the 2 carbs.
This throttle return spring fitted every HS2/4 single SU carb and also on the twins as fitted by the factory. Twin carbs used AEC2075 for choke return. Total length 90mm.
Mini Spares own performance upgrsded paper gasket that sits either side of the carb to manifold spacer on HIF38/44 type 1.75" carbs.Sold singly, order quantity as required to suit your car.
Stainless steel twin HS2 heatshields kit. Comes with link bar, bolts, nuts and springs.
Gasket for an HS4-carb and manifold .Sold seperately and order as required for your car(usually 3).
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.