($182.07) £182.07 exc vat
($218.48) £218.48 inc vat
In stock
($182.07) £182.07 exc vat
($218.48) £218.48 inc vat
In stockRecommended usage 1 x AN137 to fit one mini.
Main wiring grommet that fits in the front parcel shelf. ID 12.5mm fits 35mm hole.
Rear wiring harness for Mini Pickups pre-1979.
Was HAM3066 main loom less the wing side repeaters but superseded by Rover to this loom with side repeaters on wing,although the manufacturer of these looms always added them to HAM3066 anyway -Inertia starter, Ballast coil, Instrument cluster in fro...
Rear body harness with speaker wires, known as thick wall type which was replaced by thin wall PVC covered wire type in 1989. AN169 is the thin wall equivalent and occassionly fitted or found on early cars wothout any problems.
...
Universal post type battery earth strap with clamp type fitting and correct length for most alternatives of batteries fitted.
A plastic lamp spade connection with sidelight bulb aperture for use on sealed beam units only. Uses a GLB501 capless bulb. The mini clubman used sealed beams but had independant side lamps and therefore had an equivalent unit less the s...
Braided rear part loom ONLY for MK1 Minis without a rear heated screen.
Large grommet to fit 1"approx holes in bulkhead for items that need to be able to flex and move such as capillary tubes and oil pipes. 7/32" hole size.
The small hole will expand and is also used as wiring loom through bulkhead and battery c...
This plug fits the hole in the inner wing where the wiring for the wing side repeater lamp goes through the body on cars after 1986.
Electronic ignition conversion. For points type distributors, fixed or sliding. Negative earth only. Also, available for earlier 23/25D on Negative earth (LU142) or earlier 23/25D with Positive earth (LU142AP12).
ONLY use GCL217 coil for bal...
Single bullet connector used to join the front loom to the rear loom near the wiper motor.
Double bullet connector used to join the front loom to the rear loom enar the wiper motor.
Modern dry coil with extra strong spark--latest technology but looks the same shape of the wet body original so it looks correct on your classic mini.
Can be mounted anyway up without any chance of leaking. For non ballasted system only.
Original mini coil fitted to all cars up to 1983.
3ohms
NOT for ballast type ignition systems.
Our research, sales and feed back shows Intermotor coils to be the best available for the mini.
Original type coil bra...
This is the plug that fits all Mini alternators, except MPI. The three conections are alternator output, 12 volt sense and ignition lamp. Ideal when converting from a dynamo.
Almost any screw will hold the chrome headlamp bezel on, but only one is correct! These screws are stainless steel and will never corrode plus they have the little rubber washer on the backside so that the screw will not fall out when trying to fit ...
This is the latest model fuse box as used on all Minis after 1976 and all MG Midget/Sprites with 1275cc. Simple and easy to replace or upgrade from the earlier version. This box has the added advantage of having 4 fuses in place of the earlier vers...
This is the spiral wound cable that is in the wiper rack tubes. It needs to be cut to length.
Total length uncut is 150cm.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.