($185.17) £185.17 exc vat
($222.20) £222.20 inc vat
In stock
($185.17) £185.17 exc vat
($222.20) £222.20 inc vat
In stockRecommended usage 1 x DASH006 to fit one mini.
handbrake handle in Burr walnut to compliment the wooden dashes.
The inside is rough finished and depending on year of car tape will have to be
used on the lever to make this a snug fit.
See also MSA0193 door ...
Walnut Burr gear lever knob.
Standing 4 inches tall and carved from billet burr walnut, it really makes a statement. It has a Mini winged logo pattern embossed.
door window winder handle pair in Burr walnut finish to compliment the wooden dashes.
If your old screws do not fit see G285
See also MSA0193 door opening handles, MSA0191 door cappings and MSA0192...
Most popular of our dashes ,this fits the 3 clock cluster fitted as standard.
Black dashboard for right hand drive cars with 3 clock cluster in front of driver and with 3 extra gauge holes.
Most popular of our dashes ,this fits the 3 clock cluster fitted as standard.
Fresh air vent for the dash, these bolt to the bulkhead and the eyeball socket vents fit into them. These used to be handed but this vent has both hole patterns so will fit both sides. This replaces 37H7035, 37H7036, JJB101000 and JJB101010. Sold ind...
Black vinyl dash liners suitable for 2 and 3 clock clubman type dash with the offset clocks (Right Hand Drive).Vinyl will need cutting out for vent holes but the cardboard backing is pre cut
Printed circuit board for pre 1989 cars with Smith's type 3 clock gauge clusters. These have been unavailable for many years but have now been remade exclusively for Minispares.
2 outer rings and 2 inner knobs which have to be stuck on.
The black vinyl covering that lays on your lower dash shelf. For cars after 1970 where the facia panel is not a full metal panel you must fit (link)DT3076(/link)
Fitted for safety regulations to all MK2 minis from 1967-80 except Sweden and Canada to 1975 (not any MKI or van and pick up). Later commercial type minis did have it fitted with 3 clock speedo pod. This is a hard foam pad at the lower edge of the pa...
Black painted liners for deluxe cars with air vents and central speedo and 2 gauges.
Headlining kit for MPI cars, this is grey cloth as apposed to vinyl (much nicer in our opinion). Rear C post panels included.
MK3 Black Mini door and rear quarter trim(4 piece kit) in vinyl as per original twin line pattern per Mini and CooperS but for cars after May 1973 where the rear quarter panel trim shape did not have a cut out for the ash tray mount and if you look a...
3 point automatic rear seat belt. These seat belts do not use the standard C post nor the MPI fixing in the rear pocket. They require the fitting of the real on to the parcel shelf. These seat belts will work for all minis up to 1996
<...
Auto retractable seat belt kit. Sold per seat. The manufacturer states that these belts are direct replacements for the pre tensioner types fitted in Europe.
It will arrest the wearer within the same tolerances without a need for a...
Special shaped overmats for your Mini with our Mini Spare logo--one of our bset sellers. Overmats with Mini and Mini Cooper on are no longer available as BMW own the copyright and stopped our manufacture afer 15 years.
White with mirror aftermarket sun visor for Mk3 models from 1977 -92 which were thinner than pre December 1965 for safety crash requirements. Check out the special clips to hold these visors as they are sold seperately in car sets only as [link]SV202...
One pair (saloon car set) of rear quarter door cards in black , 1976 - 1980
These headlinings are held in by different shape/length rods which are NOT included but we do include the rear corner side sections between the rear side window and backlight which many poor copies do not,
the rods are
red end x...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.